NETGEAR Nighthawk X6S EX8000 Do More Booklet page 13

I am connected to NETGEAR_EXT and launched a browser and I can't
I see the web browser setup guide. What can I do?
Try these troubleshooting steps:
• Make sure that your computer is set up to use DHCP (most are).
• Make sure that the Client LED is white and that you are using a valid
IP address.
Relaunch the web browser and enter www.mywifiext.net in the
•
address field. Enter your admin email address and password and click
the LOG IN button.
• If you are installing the extender as an access point, make sure that
you are connecting your computer or WiFi device to the extender
through a WiFi connection instead of an Ethernet connection.
How do I restore the extender to its factory default settings?
1. Use a sharp object such as a pen or paper clip to press and hold the
Reset button on the extender for at least five seconds until the Link
Status LED, Maximum Throughput LED, 2.4 GHz LED, and 5 GHz LED
blink white.
2. Release the Reset button and wait for the extender to reboot.
The extender resets and returns to the factory default settings.
13