Region Welding Regency II Instructions

#4 Truman Court
Union, MO. 63084
Web: www.regionwelding.com
E-mail: info@regionwelding.com
Phone: 636-583-4110
Fax: 636-583-6508
REGENCY II, 6' PROPANE GRILL INSTRUCTIONS.
Open lid: Making sure latch is secured in slot.
Before lighting, propane tanks must be purged properly
Keep lid open, turn tank valve on slowly. Turn burner valve (black knob) on pilot, then
push igniter button & continue to hold black knob for 30 seconds. ~elease and turn
black knob to the ON position, slowly.
If pilot is not lit, repeat above process. If flame would jump in tube, SHUT OFF, let cool
and repeat.
Do not force knob when turning the knob to the OFF position, depress knob slightly.
Do not depress knob completely to turn off.
When burning properly, close lid to get desired temperature
&
place meat on screen.
Flame can adjusted by turning green air mixer. Capacity is large, so let heat thoroughly.
40# cylinder is necessary & will burn approximately 7-8 hours. Operates more
efficiently with lid closed. Keep both dampers open on both ends for flame will go out.
Clean Up: Do not pressure wash burner, only grease shield & screen. Check for any
obstructions in burner holes. Brush or spray vegetable oil on screen to prevent rusting.
*If problems with black on meat, or temperature not getting hot enough, check: Air
mixer (attached to burner) to make sure it is open enough to get air. Also, if more heat
is needed, charcoal or mesquite chips may be added to drip pan along with the use of
propane.
NOTE: When attaching thermocouple to safety valve, DO NOT OVER-TIGHTEN, hand
tighten and use wrench only to snug up. IF over-tightened, ceramic can damage and
cause a malfunction.