Metalumen Grande RM4D Series Installation Instructions

IS-0244-03 rev.00
GRANDE RECESSED TBAR LED
INSTALLATION INSTRUCTIONS
NOTE:
The following instructions provide general guidelines for product installation. For additional information consult the
applicable electrical codes or contact factory directly for support before attempting anything with uncertainty.
CAUTION:
Do not assemble fixture runs on floor
WARNING:
Risk of fire and electrical shock. DISCONNECT POWER AT ELECTRICAL PANEL before installing or
servicing this product.
General Safety Instructions:
1. Read all instructions prior to installing this fixture.
2. This product must be installed in accordance with the applicable installation code by a person familiar with the
construction and operation of the product and the hazards involved.
3. All wiring must be performed by a qualified electrician in accordance with national and local building and electrical codes.
4. This fixture must be suitably grounded for your protection against shock hazards and to assure proper operation.
5. Make sure that the power source conforms to the requirements of this fixture.
C
Wiring Diagram:
Specifications and design subject to change without notice.
www.metalumen.com
.
A
E
D
F
Standard wiring
MAIN PARTS LIST:
A. Luminaire enclosure
B. Tbar Hanger Bracket
C. End plate
D. Lens
E. Lens Filler &Magnet
F. Retainer Clip
OTHER PARTS:

Reflector/LED assembly
With optional Emergency Pack
570 Southgate Drive, Guelph, Ontario, Canada, N1G 4P6
Phone: 800-621-6785 Fax: 519-822-4589
Page 1 of 4