Summary of Contents for Audioaccess CATC/2WSI
- Page 1 PN 502-00100-04 CATC/2WSI Intelligent Two Way Serial Interface OFTWARE PROGRAMMING Firmware Version 1.1.0.0 and higher ARDWARE CONNECTION UIDE JANUARY 20, 2006...
-
Page 2: Table Of Contents
RS-232 connection. If pin 2 is TxD at the Interface Board, pin 2 at the computer or subsystem end must be RxD. Set the CATC/2WSI JP1 jumper accordingly (refer to the chart on page... -
Page 3: Connection To Audioaccess Bus
PX-700! If you are using the CATC/2WSI with the optional power, you may still be able to use the touchscreens to access the attached devices if the PX-700 becomes nonfunctional, or needs to be removed for service. This would be most useful for non-audio control such as Lutron Lighting systems. - Page 4 - 4 - NOTE: The plug in J1 on the CATC/2WSI automatically disconnects power from the keypad bus – you do not have to disconnect the power wire between the Interface Board and the KPT. CATC/2WSI Installation and Connection Guide...
-
Page 5: Interface Setup
Note: You must have firmware version 1.1.0.0 or higher to control all devices listed on the below chart. If you do not have this firmware please call Audioaccess Technical Support for the upgrade instructions. Please contact Technical Support if you need help determining your version. All units shipped after November 1, 2006 have the version 1.1.0.15. -
Page 6: Catc Easy Touch Ii Programming
These are available on the Audioaccess Technical Support website. There are only three steps necessary to correctly program the CATC and CATC/2WSI. If you are using the Lutron Homeworks interface please see the detailed instructions on the Audioaccess Technical Support Website before continuing. - Page 7 Congratulations! You have now completed the programming for the 2 way interface and the necessary components of the CATC. Complete the rest of your project and download to the CATC when done. CATC/2WSI Installation and Connection Guide - 7 -...
-
Page 8: Troubleshooting
888.691.4171 FAX: 516.682.3510 ©2006 Harman International Industries, Incorporated. All rights reserved. Audioaccess & Harman International are registered trade marks of Harman International Industries, Incorporated. Apple and iPod are registered trademarks of Apple Computer, Inc. CATC/2WSI Installation and Connection Guide - 8 -...
Need help?
Do you have a question about the CATC/2WSI and is the answer not in the manual?
Questions and answers