Snapper XD 1696864 Owner's Manual page 13

OPERATION
NOTE: For second and final cuts (from top of limb or branch), hold front cutting guide against the limb being cut. This will help
steady the limb and make it easier to cut. Allow chain to cut for you; exert only light down-ward pressure. If you force the cut,
damage to the bar, chain, or motor can result.
• Release the trigger as soon as the cut is completed. Failure to follow proper cutting procedures will result in the bar and
chain binding and becoming pinched or trapped in the limb. If this should happen:
• Stop the motor and remove the battery from the polesaw.
• If the limb can be reached from the ground, lift the limb while holding the saw. This should release the "pinch" and free the saw.
• If the saw is still trapped, call a professional for assistance.
LIMBING AND PRUNING
• This unit is designed for trimming small branches and limbs up to 6 in. (15.2 cm) in diameter. For best results, observe the
following precautions:
• Plan the cut carefully. Be aware of the direction in which the branch will fall.
• Branches may fall in unexpected directions. Do not stand directly under the branch being cut.
• The most typical cutting application is to position the unit at an angle of 60° or less, depending on the specific situation. As
the angle of the polesaw shaft to ground increases the difficulty of making the first cut (from underside of limb) increases.
• Remove long branches in several stages.
• Cut lower branches first to allow the top branches more room to fall.
• Work slowly, keeping both hands on the saw with a firm grip. Maintain secure footing and balance.
• Keep the tree between you and the chain while limbing. Cut from the side of the tree opposite of the branch you are cutting.
• Do not cut from a ladder; this is extremely dangerous. Leave this operation for professionals.
• Do not make the flush cut next to the main limb or trunk until you have cut off the limb further out to reduce the weight.
• Following proper cutting procedures will prevent stripping the bark from the main member.
• Do not use the polesaw for felling or bucking.
• To prevent electrocution, do not operate within 50 ft. (15 m) of overhead electrical lines.
• Keep bystanders at least 50 ft. (15 m) away.
LOAD
Second Cut
First Cut
1/4 Diameter
Final Cut
See figure 10
13
Figure 9
(15 m)
Figure 10