Stealth XP-NIghthawk Device Set Up

Download this manual

XP-NightHawk Device Set Up

In order to setup the transmitter and headset, you will find set-up instructions

included in the packaging.

Before set-up, please charge your headset by plugging the Micro USB into the

headset and the other end into an available USB port on your device. A little

LED will light (situated on the base of the headset) solid RED to indicate

charging, after around 4-5 hours the RED LED light will turn off to indicate the

headset is fully charged and ready for use.

Once the transmitter and headset has been set up on your chosen format,

please find below instructions on how to set up your new gaming headset

within your device.

Once your all connected with the headset and transmitter, Please follow the

below:

1. Power on the headset by holding the Power Button.

(The headset and transmitter LED's will begin to flash BLUE)

2. Press the Pair button. The LED's on both the headset and the transmitter

will light solid BLUE to signal the headset has been paired with your

device.

If you are experiencing problems setting this up on your console, please do

not hesitate to contact one of our friendly team.

PLAYSTATION 4

After you have powered the PS4 console one, go to...

SETTINGS > SOUND and SCREEN > AUDIO OUTPUT SETTINGS > PRIMARY OUT

PORT > DIGITAL OUT (OPTICAL) > Remove the tick from DOLBY DIGITAL 5.1ch

and DTS 5.1ch.

Then please go to the following:

1. AUDIO OUTPUT SETTINGS > AUDIO FORMAT(PRIORITY) >

"SELECT LINER PCM"

Page 1 XP-NightHawk Device Set Up In order to setup the transmitter and headset, you will find set-up instructions included in the packaging. Before set-up, please charge your headset by plugging the Micro USB into the headset and the other end into an available USB port on your device. A little...
Page 2 2. SETTINGS > DEVICES > AUDIO DEVICES > OUTPUT TO HEADPHONES > “SELECT ALL AUDIO” To set up your microphone please go to the following: 1. SETTINGS > DEVICES > AUDIO DEVICES > OUTPUT DEVICE > “SELECT USB HEADSET (2.4G WIRELESS HEADSET)” Once set-up on your chosen device, the MICROPHONE MUTE function is operated by pressing the PAIR button (Mic Mute Icon) on the headset.
Page 3 1. Select the “SPEAKER ICON” (Image) and use the right click button to show full list of options > select SOUND. 2. Select “PLAYBACK” tab > choose STEALTH NIGHTHAWK > Click mouse to choose “SET DEFAULT” 3. Go to “RECORDING” Tab > Choose STEALTH NIGHTHAWK > Click mouse to choose “SET DEFAULT”...
Page 4 1. Select SYSTEM PREFERENCES > SOUND > Select INPUT tab > Select STEALTH NIGHTHAWK. 2. Go to OUTPUT tab > Select STEALTH NIGHTHAWK 3. Go to SOUND EFFECTS tab > Tick all as pictured. Mac settings configuration is now complete –please test both microphone and...