Advertisement
installation
Before installing your new mixer, flush
through the pipework to ensure removal
of debris, turn off the water supply.
Warning! Please check for any
hidden cables and pipes before drilling
holes.
Position the seat and mark the 3 fixing
holes, remove the seat and drill the 3 x
12mm holes to the required depth.
Insert the expansion bolts into the holes.
Slide the seat over the studs followed
by the 3 washers and nuts. Use the
adjusting screws to level the seat, when
satisfied with the level finally tighten
down the bolts.
Connect the inlet pipes to the seat with
the hot on the left and cold on the right.
Nut
Washer
Seat
Bolts
Seat
Adjusting
screw
Bolts
Cold inlet
Front
Hot inlet
installation
Finish the floor covering down to a
diameter of 75 to 89 mm.
Remove the 2 screws and pull out
the safety cover.
Insert the main body assembly into
the seat, tighten the fastening plate,
and cover with the escutcheon.
75-89mm
Floor
Screws
Safety
cover
Seat
Escutcheon
Fastening
plate
Seat
Advertisement
