1. Manuals
  2. Brands
  3. Art-Tech Manuals
  4. Science Education products
  5. AT-EG301
  6. Manual

Art-Tech AT-EG301 Manual

Hide thumbs
1
2

Advertisement

Table of Contents

This gyroscope uses digital PID control method. It has a built-in temperature compensation circuit and
thus greatly reduces the impact of temperature change on the midpoint offset. It has two working
modes: locked mode and standard mode. With multi-gain controls and many adjust methods, this
gyro can perform head-lock function easily.It is easy to fit different kinds of helicopters. It is a good
choice for hovering, flying routes, reverse flight and other stunt flying.

Gyro adjustment

Picture of control set connection

Feature

1. Built-in lock mode and standard mode
2. Built-in temperature compensation circuit
3. Multi-gain control adjustment function
4. Gyroscope normal/reverse direction switch
5. Rudders itinerary adjustment function
Gyroscope (AT- EG301)Manual
1.Rudder itinerary adjustment
3.Connect to tail servo
4. Reverse switch for servo
5.Gyro gain Connect to Ch5
6.Gyro signal Connect to Ch4
6. Pitch
5. Gyro gain
4. Rudder
3. Throttle
2. Elevator
1.Aileron

Specification

1. Working Voltage : DC 4V-6V
2. Working currency: 40mA
3. Weight: 15g
4. Dimension: 31mm * 31mm * 23mm
connect to
tail servo

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AT-EG301 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Art-Tech AT-EG301

  • Page 1 Gyroscope (AT- EG301)Manual This gyroscope uses digital PID control method. It has a built-in temperature compensation circuit and thus greatly reduces the impact of temperature change on the midpoint offset. It has two working modes: locked mode and standard mode. With multi-gain controls and many adjust methods, this gyro can perform head-lock function easily.It is easy to fit different kinds of helicopters.
  • Page 2 Installation and operation steps 1. Make sure the radio control system and the servos are in good working condition,and the angle of the servo arms are installed correctly. 2. Fix the gyroscope to the right position close to the location of the center of gravity as in the picture. 3.

Table of Contents