Section 5: Product Warranty & Contact Info; 5-1: Factory Direct Limited Lifetime Warranty; 5-2: Emission Legality Statement - Hypertech Max Energy 2.0 Reference Manual And Step By Step Installation Manual

Note: The Max Energy 2.0 is designed to use on only one vehicle at a time. In order to use the programmer on
another vehicle, the vehicle it is currently being used on must be returned to stock by following the Back To
Stock procedure in Section 2. Once the programmer has been returned to stock, it can then be used on another
vehicle, if that vehicle is supported by the programmer.
The Max Energy 2.0 is limited for use on a maximum of three (3) vehicles. Each time the programmer is
connected to a vehicle, the VIN number is stored in the programmer memory. Once the programmer has a third
VIN number stored, it will no longer be able to be reused on another vehicle. Warranty coverage is only for the
original purchaser, and on the original vehicle the programmer was used on.
Additional licenses for new vehicles can be purchased from Hypertech. To order, call our Tech Department at
901-382-8888, or email techsupport@hypertech.com, with the serial number off of the programmer.
5-2: Emissions Legality Statement
All applications supported in the Max Energy 2.0 California Edition, part #2100, are covered under CARB
EO #'s D-260-18, D-260-19, and D-260-20, making it legal for sale or use in all 50 States, including California
pollution-controlled motor vehicles, according to the CARB Executive Order process. In the interest of
improved air quality, the California Air Resources Board (CARB) requires new vehicle and manufacturers of
aftermarket parts to develop engine and emissions equipment that either reduce or maintain specific air
pollutants affected by vehicle use. Both the California Vehicle Code (section 27156) and Federal Clean Air Act
(administered by the Environmental Protection Agency) prohibit modifications that increase vehicle emissions.
Aftermarket parts manufacturers, particularly in the high-performance segment, are required to obtain CARB
approval in the form of Executive Orders (E.O.s) for any product not qualifying as a direct replacement for an
original equipment part. This includes meeting all E.O. requirements in its product development process. This
guarantees that users of this product will meet certification requirements when registering, selling, or needing to
pass various emissions tests or Inspection and Maintenance (I&M) programs administered by state or local
enforcement agencies.
Make sure that any emissions-related product you buy and install carries an E.O. number or is pending an E.O.
Without this verification you are at risk, in potential violation of regulations and may incur unnecessary
financial obligations during vehicle inspections or emissions tests. To verify if your vehicle application is 50-
State emission legal, go to www.Hypertech.com, and look up by vehicle year/make/model.
5-3: Contact Info
Tech Department
901-382-8888 Phone
901-373-5290 Fax
techsupport@hypertech.com
Office Hours: Monday-Friday, 8AM-5PM Central Time
Hypertech, Inc.
3215 Appling Rd.
Bartlett TN 38133
www.hypertech.com
33