Max-Air Systems 2000-210 Instructions For Use

CAUTION
!
Before use, refer to the CAPR
O.N. 2000-210
P/N 03531271
Front Strap on
Front Rivet

Symbol Definitions

!
Warning, Caution, or Note
O.N.
Order Number
!
WARNING
Use only if package is received unopened and contents are
undamaged. If damage is noted, contact the shipper for replace-
ment or repair.
Prior to using any MAXAIR
®
familiar with the system's NIOSH approved configuration.
DO NOT use if any component is damaged. If any components are
damaged or contaminated and therefore unfit for safe and effective
use, they should be replaced immediately.
Only trained and experienced personnel who have read and under-
stand the User's Instructions should use this product.
Failure to follow the User's Instructions, these and in the MAXAIR
Systems User's Instructions, P/N 03521015, may be hazardous to
the user's health.
The institution using this product in any application is responsible
for determining the appropriateness of this equipment relative to
regulatory requirements. Bio-Medical Devices Intl, Inc. does not
recommend the appropriate systems for a particular institution or
facility.
Use only MAXAIR Systems/ NIOSH approved compatible
components.
NOT for use in atmospheres immediately dangerous to life or health
(IDLH), and atmospheres containing less than 19.5% oxygen, or
more than 25% oxygen.
If you need more information, contact your BMDI Sales
Representative, or call BMDI customer service at 1-800-443-3842.
User's Instructions, P/N 03521015 (received with all CAPR Helmets) for System Details.
®
Long, Rear
Rivet Straps
Short, Front
Rivet Straps
Rear Strap on
Rear Rivet
P/N
Part Number
System or component, be sure to be
2000-210 4-Point ChinStrap
Instructions For Use

Intended Use

The MAXAIR Chin Strap is an accessory item for MAXAIR Hard
Hat configurations that enhances Helmet-to-head secureness of
fit. This may be helpful for applications where a worker's activity or
environmental factors could otherwise dislodge the Hard Hat from
its properly donned position.

For Use With

The Chin Strap may be used with any MAXAIR Hard Hat System
configuration.

Typical Hard Hat System Components

1 2
7
1. 2061-04A Hard Hat
3. 2083-03 Helmet with Liner
and Power Cord, and 2167-10
Filter Cartridge
5. 2000-76 Battery Belt
7. 2000-210 4-Point ChinStrap
Head/Face Cover Alternates
2264-01 ML & SM
DLC Shroud
NOTE
!
The 2500-36TSC, 8-10 Hr./Charge is an alternate
battery.
The 2166-10 N-OV is an alternate Filter Cartridge.

Specifications

System Temperature Limits: 49

Materials

Nylon Hooks
Acetal Buckle and Keeper
Polypropylene Strap
Polyester Buckle

Regulatory

NIOSH
ANSI Z87.1
3 4 5
2. Optional 2400-090L Impact
Lens
4. 2500-37TSC Battery, 12-15
Hr./Charge
6. 2600-01 Battery Charger
2366-01 ML & SM
DLC Lens-Cuff
C
0
P/N 03523278 Rev A Page 1
6