Table of Contents
Advertisement
Quick Links
MG ANODI
INTERNATIONAL AD
Velikotarnovsko Shosse 1
5400 Sevlievo – Bulgaria
Mobile: +39 345 8412837
Web: www.mg-anodi.com
E-mail:
aces@mg-anodi.com
CGR srl
MG ANODI INTERNATIONAL AD
via V. Bottego, n.41
Velikotarnovsko Shosse 1
41126 Modena - Italia
5400 Sevlievo - Bulgaria
tel.- fax +39 059822673
Mobile: +39 345 8412837
Web: www.mg-anodi.com
WEB: www.cgr-aces.it
E-mail: aces@mg-anodi.com
EMAIL: info@cgr-aces.it
Advertisement
Table of Contents
Summary of Contents for MG ANODI De Stefani ACES
- Page 1 MG ANODI CGR srl MG ANODI INTERNATIONAL AD INTERNATIONAL AD via V. Bottego, n.41 Velikotarnovsko Shosse 1 Velikotarnovsko Shosse 1 41126 Modena - Italia 5400 Sevlievo - Bulgaria 5400 Sevlievo – Bulgaria tel.- fax +39 059822673 Mobile: +39 345 8412837 Mobile: +39 345 8412837 Web: www.mg-anodi.com...
- Page 2 ENGLISH from page 1 to page 12 (rev. 02)
-
Page 3: Table Of Contents
CONTENTS English Using the manual Symbols Description of the product 3.1 Permissible/improper use Supply specifications Installation and startup 5.1 Electronic device installation 5.2 Anode installation 5.3 Device installation 5.4 Startup Troubleshooting Maintenance Spare parts Warranty Instructions regarding disposal ACES - ACES G2 technical card 10-11 Manufacturer’s declaration of conformity 1. -
Page 4: Symbols
ATTENTION This handbook must be consulted by the customer for correct installation attention messages and use of the product. indicate risk of damage to The user must strictly comply with the the equipment during operation or safety instructions given in it. maintenance work, if the procedures The manufacturer declines any liability and conditions described are not... -
Page 5: Description Of The Product
The correct polarity of the cables must strictly size of treated part: 3 mm respected during installation stage: wire ending with faston contact For stainless steel, MG ANODI INTERNATIONAL will prepare a design according to the characteristics and capacity of the boiler. -
Page 6: Supply Specifications
The integrity of the contents during transport is obtained by placing protection material such polystyrene inside the packing. The weight of the load to be handled is always specified on the outside of the packing. With large supplies, the weight of the load may exceed 30 kg. -
Page 7: Installation And Startup
SCREWS If the lack of right to the warranty In both cases, proceed as follows (see is ascertained, MG ANODI will get figures 3.1 and 3.2): the opinion of the customer who - make two holes (in the wall or... - Page 8 The anode is supplied protected by a plastic protection. Remove FIXING the protection before installing HOLES the anode. The user must not operate in any way on the activated part of the anode (terminal end), to clean it or other, since similar activities...
- Page 9 figure 4.2: example of assembly in water figure 4.2: example of assembly in heater-horizontal anode water heater-vertical anode anode support inlet hole anode wall-mounted generator anode wall-mounted generator anode support inlet hole figure 4.3: example of assembly on -2- fix the anode by screwing it on the boiler with coil hole in the tank;...
- Page 10 In case of specific requests by the user, MG ANODI INTERNATIONAL can 6. TROUBLESHOOTING supply any additional anodes with respective single-core cable. As already illustrated, the ACES device...
-
Page 11: Electronic Device Installation
SCREWS If the lack of right to the warranty In both cases, proceed as follows (see is ascertained, MG ANODI will get figures 3.1 and 3.2): the opinion of the customer who - make two holes (in the wall or... - Page 12 Size of electrodes: various sizes depending on the characteristics of the tanks to be protected size of treated part: 3 mm For stainless steel, MG ANODI INTERNATIONAL will prepare a design according to the characteristics and capacity of the boiler.
- Page 13 The correct polarity of the must strictly size of treated part: 3 mm cables respected during installation stage: wire ending with faston contact For stainless steel, MG ANODI INTERNATIONAL will prepare a design according to the characteristics and capacity of the boiler.
- Page 14 DICHIARAZIONE DI CONFORMITA’/ DECLARATION OF CONFORMITY MG ANODI INTERNATIONAL AD Fabbricante/Manufacturer: Velikotarnovsko Shosse 1 5400 Sevlievo – Bulgaria Descrizione del prodotto/ Product(s) description: Dispostivo elettronico anticorrosione per bollitori/Electronic devices for boilers and water-heaters corrosion prevention: A C E S Serie H...
Need help?
Do you have a question about the De Stefani ACES and is the answer not in the manual?
Questions and answers