Advertisement
Measurement Operation:
(1) Hold the meter and point it towards the surface to be measured.
(2) Press and hold the Measurement Trigger to turn the meter ON. LCD will show a reading. If there is NO display
or reading, the battery may have depleted. Replace the battery and try again.
(3) Push the Laser select button while pressing and holding the Measurement Trigger to turn ON the laser beam.
Laser icon will appear on LCD above temperature. Aim the red laser beam approximately 1/2" above the point
Note:
of test. (
pressing the Laser select button again turns the laser beam OFF).
(4) Select the unit of temperature (°C or °F) by first pressing and holding Measurement Trigger and then using
°C select button or °F select button.
(5) Press the Backlight button to turn ON the LCD backlighting function.
(6) Release the Trigger and the HOLD display icon will appear on the LCD indicating that the reading is being held.
(7) The meter turns OFF automatically 7 seconds (app.) after Measurement Trigger is released.
Measurement Considerations:
Holding the meter by its handle, point the Infrared (IR) sensor towards the object whose temperature is to be
measured. The meter automatically compensates for temperature deviations from ambient temperature. Keep
in mind that it will take up to 30 minutes to adjust to a wider range of ambient temperatures.
Battery Replacement:
When battery power is not sufficient, LCD will display.
Notes:
How it works
Infrared thermometers measure the surface temperature of an object. Meter's optics sense the energy emitted,
reflected or transmitted from an object and collects and focuses onto a detector. The electronics then translate the
information into a temperature reading, which is displayed on the LCD. In thermometers with a laser beam, it is
used for aiming purposes only.
Field of view
Make sure that the target is larger than the meter's spot size. The smaller the target, the closer you should be to it.
When accuracy is critical, make sure the target is at least twice as large as the spot size.
4
You will need a new 9V battery.
www.jetequipment.com
Advertisement
