THESE INSTRUCTIONS MUST REMAIN WITH THE FURNACE AFTER INSTALLATION
Furnaces acceptable for use with RXGW-B01 Chimney Adapter are also identified by a label located
on the furnace top plate as shown below:
This vent kit must be installed by a qualified service technician exactly as specified
This kit must be installed by a qualified service technician exactly as specified
in these instructions and all applicable State and local codes. In the absence of
in these instructions and all applicable State and local codes. In the absence of
local codes, installations must conform to the latest edition of the National Fuel
local codes, installations must conform to the latest edition of the National Fuel
Gas Code (ANSI Z233.1) or National Standard of Canada for natural gas and
Gas Code (ANSI Z233.1). Failure to follow these instructions may result in
propane installations (CAN/CGA B149.1 & .2). Failure to follow these instructions
fire, explosion, or the production of carbon monoxide causing structure
may result in fire, explosion, or the production of carbon monoxide causing
structure damage, personal injury or loss of life.
Do Not Use This Kit to Vent Category II, III, or IV Furnaces
Do Not Use This Kit on Standing Pilot Furnaces
RXGW-BO1
Chimney Adapter Kit For Upflow Only,
Category 1, Fan Assisted 80+ Furnaces
THIS APPLIANCE IS CSA
CERTIFIED FOR USE WITH
RXGW-BO1 CHIMNEY ADAPTER
WARNING
WARNING
damage, personal injury or loss of life.
WARNING
92-101682-01-02