Factory Programming And Calibration - Adam CFW Series Service Manual

After calibration the scale should be checked for whether the calibration
and linearity is correct. If necessary repeat calibration, make sure that
the scale is stable before accepting any weight.

7.0 FACTORY PROGRAMMING AND CALIBRATION

• The parameter "PROG" allows access to the calibration section. To
enter this parameter press [Func] and then press [Tare/ ] until
"PROG" is displayed.
• Press [Zero/Enter] when "PROG" is displayed to show " PIn ",
requesting for the security password.
• Press the [Units], [Func] and [Print] keys in sequence to enter the
Programming/ Calibration menu.
Press [Zero/Enter] to set the functions of "P1 rEF".
• The Programming Parameter "PROG" has a number of sub-
parameters that allow the scale to be customised for the
application.
that can affect the metrology of the scale. These functions should
not be reset to other values unless you understand the affect it may
have on the scale.
SETTING OF SERVICE PARAMETERS
SUB- FUNCTIONS
PARAMETER
P1 rEF AZn 0
@Adam Equipment Company 2007
The "P1 rEF" sub-parameter includes many functions
DESCRIPTION
Auto Zero operating range.
(Options: 0.5d, 1.0d, 2d, 4d)
Sets the operational range of the auto
zero function.
12
The display will show "P1 rEF".
DEFAULT
SETTING
1d