Page 2
This product should be installed in accordance with all local and state plumbing and building codes. WARNING: This product has been designed for use with the Pfister 01-31XA series valve. It will not work with any other product.
Page 3
4 COMPONENT REMOVAL For removal of HOT and COLD Water Valves (4A/4B), be sure Stems (4C) are in the full ON position and water is turned off. Remove old unit such as Trim (4D), Flanges (4E), Nipples (4F) and Valves (4A/4B/4G), as shown. Clean the mounting surface thoroughly.
Page 4
6 NEW COMPONENT INSTALLATION Insert Rubber Washers (6A), Hot/Cold Valves (6B/6C) and Diverter Valve (6D) into existing Valve Body (6E). Set Stems (6F) in the CLOSED position. Position Flanges (6G) on Valves (6B/6C/6D) with Drain Hole (6H) at the bottom. Screw Retainer Sleeves (6J) onto threaded section of the Stem (6F).
Page 5
7 SHOWER ARM INSTALLATION Remove existing Shower Arm and Shower Flange. Insert the long end of Shower Arm (7A) through the Show- er Flange (7B). Apply PTFE plumber's tape to both ends of Shower Arm (7A) according to manufacturer's instruc- tions.
Page 6
For warranty information go to www.pfisterfaucets.com Para la información de la garantía vaya a www.pfisterfaucets.com Pour l’information de garantie allez à www.pfisterfaucets.com Pfister Pfister Pfister Lifetime Limited Mechanical & Pfinish Garantía Mecánica y sobre el Acabado Une garantie limitée à vie pour ce qui est...
Need help?
Do you have a question about the Avalon S104-3 and is the answer not in the manual?
Questions and answers