Advertisement
ARB COMPRESSOR MOUNTING KIT
Installation Instructions
Please read all instructions before proceeding with installation.
Warranty Information: This item is sold without warranty expressed or implied. The user assumes the risk of the product's ability to
protect the user from injury or death. The effectiveness and longevity of this product are in direct relation to the manner in which it is
installed, used and maintained. The user assumes all risk. The entire risk with the performance of this product is with the purchaser.
Working on you vehicle can be a dangerous activity, and if you are unsure of what you are doing, please leave mechanical or safety
critical work to a skilled mechanic. We take no responsibility for the incorrect use or installation of this product.
Page 1
REV A
04/19/2016
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for ARB Twin Bracket
- Page 1 ARB COMPRESSOR MOUNTING KIT Installation Instructions Please read all instructions before proceeding with installation. Warranty Information: This item is sold without warranty expressed or implied. The user assumes the risk of the product’s ability to protect the user from injury or death. The effectiveness and longevity of this product are in direct relation to the manner in which it is installed, used and maintained.
- Page 2 9/64” Allen Wrench Important Note Before installing the ARB Compressor Mounting Kit you must install the ARB Compressor onto the Mount. However, these instructions are shown without the compressor to better illustrate the installation process. These installation instructions contain all the steps for installing the compressor mount. Please read and follow all instructions in order.
- Page 3 Pieces & Parts Item Part Number/Description Bolt Bolt Tapered Bolt Rev Nut Washer Star Washer Bracket Angle Bracket Page 3 REV A 04/19/2016...
- Page 4 Use 9/64” Allen Wrench to tighten the bolt. 2. Install the ARB Twin Compressor to the bracket. 3. Unplug and remove the horn. It is recommended that you mount the horn on the bracket at this point, but it can be done later as well.
- Page 5 Installation 4. Remove the factory bolt using a 10mm socket. 1st bolt/hole on the top. 5. Loosen the Master Cylinder nut closest to the passenger side, using a 13mm socket and short extension. DO NOT REMOVE! 6. Using the 17/32” drill bit, drill in the 2nd hole to widen it.
- Page 6 Installation 7. Put the provided bolt, rev nut and washer together. 8. Put the rev nut in the hole that you drilled out, so it is flush with the top, tighten the nut while holding the bolt to compress the rev nut, then remove nut and bolt.
Need help?
Do you have a question about the Twin Bracket and is the answer not in the manual?
Questions and answers