Table of Contents
Advertisement
Cart Operation
The A La Cart Tablet Security/Charging Cart is designed to
charge Apple iPad, Apple iPad Mini, Kindle Fire, Barnes &
Noble Nook, HP TouchPad, Dell Streak, Samsung Galaxy.
and other devices that support charging via USB. Multiple
brands can be mixed within the A La Cart Tablet Security/
Charging Cart. Please contact MooreCo at 1-800-749-
2258 for additional compatibility information.
Before using the A La Cart Tablet Security/Charging Cart,
it must be plugged into an AC outlet (100-127 VAC) with a
minimum of 15 Amp rating. The A La Cart Tablet Security/
Charging Cart uses a maximum of 15 Amps, but should be
powered by an outlet with extra capacity.
Prior to opening or using the A La Cart Tablet Security/
Charging Cart, the locks on the two locking casters should
be engaged to prevent the cart from moving. Any time the
A La Cart Tablet Security/Charging Cart needs to be moved,
the two locks on the locking casters must be disengaged.
In order to charge a particular type of device, the
corresponding style cable must be plugged into the USB
Timer Installation
1. Align the timer assembly with the (4) pre-drilled mounting
holes under the work surface and attach with (4) screws.
Tighten securely.
2. With the switcher in the 'OFF' position, plug the cart
power strips into the timer outlets.
3. Plug the cycle timer power cord into a dedicated 15 amp
circuit in a 110-volt standard outlet
4. Secure power cords within the cart as necessary with zip
ties.
The timer prevents overload by alternating power between
both power strips in the cart, providing charging to multiple
devices during the day.
Using the Timer
1. The power strips plug into the outlets labeled 'A' or 'B'.
2. The timer is pre-programmed and permanently set to
alternate between the A and B banks every 15 minutes.
4
www.moorecoinc.com | 800.749.2258
port. For example, an Apple iPad cable is required for
charging an iPad.
The A La Cart Tablet Security/Charging Cart has a power
switch, which will be lit red when turned on. Please turn the
switch to the "off"position before unplugging the device from
from the AC wall outlet.
In the event that the A La Cart Tablet Security/Charging
Cart is plugged into an AC outlet, switch turned to the "on"
position, yet without lighting the red switch light, the cart
is not receiving power. This can be caused by a blown
fuse located inside the AC receptacle of the iTeach High
Capacity Charging Cart, or by a problem with the AC
outlet (such as a blown breaker). In such circumstances, a
properly trained technician should be contacted to address
the situation.
Device & Cable Management
1. Route one charging cord, front to back, along the
underside of the shelf for each device/slot. Make sure
that the cord end that goes into the devices is at the front
of the cart and the power end goes to the power strips
in the back. Leave enough slack in front (approximately
4.5"; use the height of the divider as a measuring stick)
so users can plug in the device without straining the
cord.
2. Plug the devices power cord into one of the power strips
at the back of the cart and place your power adapter into
the storage area beneath the shelves.
3. Insert the cord into the small clip at the front of the divider,
then wrap extra slack around cord winder clip on the
underside of the shelves.
4. Turn the power switch to the OFF position before
plugging the cart into the wall.
Advertisement
Table of Contents
