Advertisement
Quick Links
●DIGIT PANEL: Touch digits panel to activate the system.
●Default code: For 8-digit management: 12345678
For 6-digit user: 123456.
●Security alarm: If entering wrong code 3 times, digit panel will flash with alarm sound
"beep beep beep" for 30 seconds. You are not able to enter any digit at this
moment until alarm off.
SET UP AUTO / MANUAL CLOSE MODE
The lock is set to auto-close mode initially.
To switch the auto / manual mode, press the
button A at back of the lock.
●Auto-close mode (" Beep beep" sound):
The plunger will come out after 8 second.
●Manual-close mode ("Beep" sound):
An user has to enter 6-digit user code, then the plunger will come out.
Modify code:
●Change user's code
After open the lock with user code
Plunger will come out if code
•
changes successfully
●Change management's code
S D W P - 0 0 1
Electronic touch panel cabinet lock
User manual
Press "set"
Enter "new 6 digit code"
Press "OK" button again
Enter "6-digit" code again
After open the lock with management's code
Press "OK" button again
Plunger will come out if code changes successfully
**User code will default to 123456 after using management code to unlock
Lock and unlock (Under manual-close mode ):
●To unlock
Enter 6 digit code
●To lock
Enter 6 digit code
**When entering wrong code, press "SET" to erase and re-enter user code
Lock and unlock (Under auto-close mode ):
Using user 6-digit code
●To unlock and lock
Touch digit panel to activate system
•
After 6 seconds, the plunger will come out automatically
Using management 8-digit code
●To unlock and lock
Touch digit panel to activate system
•
After 6 seconds, the plunger will come out automatically
**When enter admin 8-digit code to open lock, the user's 6-digit code will default to 123456
Press "OK"
Reset
Press button "B" to reset system. Management code will
default to 12345678 and user code will default to
123456
Press "set"
Enter "8-digit" code again
Press "OK" button
The plunger goes in to "Unlock"
Press "OK" button
The plunger comes out to "Lock"
Press 2 random digits
Press "OK" button again to lock
Press "OK" button to unlock
Press 2 random digits
Press "OK" button again to lock
Press "OK" button to unlock
Enter "new 8 digit code"
Press " OK" button
Press user 6-digit code
Press admin 8-digit code
Advertisement
Summary of Contents for Armstrong SDWP-001
- Page 1 S D W P - 0 0 1 After open the lock with management’s code Press “set” Enter “new 8 digit code” Electronic touch panel cabinet lock Press “OK” button again Enter “8-digit” code again Press “ OK” button User manual Plunger will come out if code changes successfully **User code will default to 123456 after using management code to unlock Lock and unlock (Under manual-close mode ):...
- Page 2 Low voltage alarm: If voltage drops to 3.6V, digit panel will flash with alarm sound when you touch the panel. It means to remind you that voltage is low and please change new batteries. Put your finger on the panel for 3 seconds to exit alarm, and then enter your code to unlock.