Operating The Usb Ports; Operating The 12 V Dc Port; Operating The Led Work Light; Maintenance - Batavia ?MAXXSERIES BT–JS001 Operating Instructions Manual

English

14. Operating the USB Ports

• The device has two USB ports (7) with
5 V / Max. 2.4 A. These can be used as
a power source for many electronic
consumer devices (cell phones, MP3
players, digital cameras, etc.).
• First connect the desired consumer to
the USB port and then switch on the
mobile power station.
• Check the operating voltage of the elec-
trical or electronic consumer before
connecting the device to the jump
starter.
• When using the USB ports, do not use
the compressor or jump start at the
same time.
Insert the connection cable with the
1.
connected device into one of the pro-
vided USB ports (7).
To charge the connected device, turn on
2.
the device with the ON/OFF switch (2).
The display (6) shows "USB".
To stop charging, turn off the power
3.
using the ON/OFF switch (2).

15. Operating the 12 V DC Port

The device is equipped with a 12 V DC ciga-
rette lighter socket (13). It can be used for
operating 12 V consumers (lamp, camping
lights, fan, coffee maker, mobile phone, cool
box).
Connect the consumer to the 12 V con-
1.
nector (13).
Press the ON/OFF switch (2). Also
2.
press the ON/OFF switch of the
consumer.

16. Operating the LED Work Light

Turn on the device with the ON/OFF
1.
switch (2).
To turn on the LED work light (1), press
2.
the LED button (4).
To turn off the LED work light, press the
3.
LED button (4) again.

17. Maintenance

• Do not modify the device in anyway.
There is a risk of injury!
• Do not open the device yourself and do
not try to replace the built-in battery.
10
• Regularly check the cables of the red
battery terminal Plus and the black
battery terminal Minus for damage.
• In case of an operating error, have the
device repaired only by a specialist
workshop.
• To maintain the capacity of the built-in
battery, it is important to recharge the
built-in battery regularly.
• Switch on the device with the ON/OFF
switch (2).
• Switch on the LED work light (1) by
pressing the LED button (4) and then
switch off again after a few minutes.
• Switch on the compressor for approx. 5
minutes by pressing the compressor
button (11) and then switch off again.
• Charge the built-in battery, if necessary.

18. Cleaning and Storing

• Disconnect all electrical connections
before cleaning or storing the device.
• Incorrect storage and transport may
damage the device and cause battery
luid leakage.
• Never immerse the device in water or
other liquids. There is a risk of damage!
• Clean the device only with a slightly
moistened cloth and allow it to dry
completely before using it again.
• Never use aggressive or chemical
cleaning agents.
• Clean the connection terminals
regularly.
• Keep the device, especially the open-
ings, dust-free and dry.
• Store the device indoors only in a dry
place protected from extreme
temperatures.
• Secure the device in the boot so that it
cannot tip over and damage the built-in
battery
• Store the device in the storage bag, out
of the reach of children.
• Always store the device frost-proof.