Table of Contents
Advertisement
Quick Links
Hardware Kits:
A. (1) Port Side Arm
B. (1) Starboard Side Arm
C. (1) Center Plate
D. (2) Backer Plates
E. (12) 3/8" x 1-3/4" Bolts
F. (8) 3/8" Flat Thunder Washers
G. (16) Flat Thin Washers
H. (12) 3/8" Lock Nuts
STEP 1 Hold drill template to the mounting surface and mark hole locations. Do this for both sides. FIG. 1
Check all clearances.
STEP 2 Put the mounting bracket together as illustrated FIG. 2 (Do not fully tighten yet). Re-check clearances with
loosely assembled bracket.
STEP 3 Drill holes in pontoon mounting surface using template to guide FIG. 3
• Use a center punch to mark the center of hole locations.
• Drill first with a ¼" drill bit
• Finish the hole with a 7/16" drill bit
STEP 4 Repeat step 3 for the opposite side of pontoon M brace/frame rail.
Place Template
Figure 1
Need help? Contact our Technical Support Team at 1 + 813.689.9932 Option 2
PONTOON M-BRACE MOUNTING BRACKET
INSTRUCTIONS
Installation Tools:
• 9/16" Socket with ratchet
• 9/16" Wrench
• Center Punch
• Drill
• Steel Drill Bits ¼" & 7/16"
• Tape
• Marker
E
G
©2018 all rights reserved. Power-Pole Shallow Water Anchor U.S. Patent No. 6,041,730
D
G
F
Figure 2
D
A
B
C
Drilled Holes
Figure 3
E
F
G
H
Advertisement
Table of Contents
Summary of Contents for Power-Pole PONTOON M-BRACE
- Page 1 STEP 4 Repeat step 3 for the opposite side of pontoon M brace/frame rail. Place Template Drilled Holes Figure 1 Figure 2 Figure 3 Need help? Contact our Technical Support Team at 1 + 813.689.9932 Option 2 ©2018 all rights reserved. Power-Pole Shallow Water Anchor U.S. Patent No. 6,041,730...
- Page 2 If M-Brace is covered, it will need to be cut to install backer plates. See M-Brace Cuts section at bottom of page. STEP 6 Install the Power-Pole shallow water anchor by following the Hardware Kit for Adapter Plate Instructions. Backer...
Need help?
Do you have a question about the PONTOON M-BRACE and is the answer not in the manual?
Questions and answers