Brother, Brother & Sons K7 Twist Manual

K
T W I S T
7
DRIVER
SEC PRI
- +
DISTRO PCB
- + + - + - +
DRV LED1 LED2 LED3 LED4 LED5 LED6
K7 K7
K7
WARNING:
Do not connect or disconnect LEDs when power is ON.
This product is for professional use only and has been designed for indoor use. Exposure to moisture
may cause damage to the product and will void your warranty. Do not operate the product if the ambient
temperature exceeds 40°C / 104°F. Do not mount on flammable surface.
Customer service: Contact your regional dealer. Contact information can be found at www.brothers-sons.dk
The information in this manual is subject to change without notice. Go to www.brothers-sons.dk
for the latest version. Brother, Brother & Sons ApS assumes no responsibility for any errors or
inaccuracies that may appear in this manual.
Disposing of this product: This product is in compliance with the RoHS and WEEE directives
Help preserve the environment! Ensure that this product is recycled at the end of its life.
MANUAL
Do not connect to mains before going through step 1 and 2
MAINS
- + - + - + -
BROTHER, BROTHER & SONS
Installation:
1. Connect the driver "SEC - + " to the Distro PCB
"DRV - +"
EMC considerations: max. total cable length from
Driver to Distro PCB to K7 should be 10m.
2. Connecting the K7s to the Distro PCB.
The K7 cable has SQUARE insulation for positive +
You can connect up to six K7s
If you connect..
1 x K7: You do not need the distro pcb, connect
directly to the drivers "SEC - +"
2 x K7: connect to output 1 and 2, connect a
jumper cable from "LED3 +" to "LED6 -"
3 x K7: connect to output 1, 2 and 3, connect a
jumper cable from "LED4 +" to "LED6 -"
...etc.
3. Now you can connect to mains