Festool CXS Original Operating Manual page 18

CXS
100%
0%
Recommendation:
When the LED is blinking charge battery pack
before further use.
9.3 Bit store [1-10]
Magnetic, for storing bits and bit holders.
9.4 Warning signals
Power tool shuts down, capacity indicator
flashes:
Battery pack is empty.
Change the battery pack.
Power tool shuts down, capacity indicator does
not flash:
Power tool is overheating or has been overloaded.
Apply a lesser load to power tool.
Allow power tool to cool down.
10 Service and maintenance
Customer service and repair. Only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/Service
Use only original Festool spare parts!
EKAT
4
Order No. at:
www.festool.com/Service
5
3
2
1
Note the following information:
– Keep the ventilation slits on the machine free
and clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
Information on battery packs
– Store in a cool, dry place at a temperature
between 5 °C and 25 °C.
18
70 - 100%
40 - 70%
15 - 40%
< 15%
– Protect battery packs from moisture, water
and heat.
– Do not leave empty battery packs in a charger
disconnected from the mains power supply for
longer than one month. Danger of deep dis-
charge!
– If you intend to store li-ion battery packs for
longer periods without use, you should charge
them to 40 % capacity (approx. 15 min charging
time).
– To avoid short circuits the battery pack should
bestored in the packaging supplied.
11 Environment
Do not throw the device in household
waste! Recycle devices, accessories
and packaging. Observe applicable
national regulations.
Return used or faulty battery packs to your local
specialist retailer, Festool after-sales service
or nearest public waste management facility
(observe applicable regulations). Batteries must
be discharged on return. Battery packs will then
be recycled.
12 Transport
The lithium-ion batteries are subject to the re-
quirements of the legislation on hazardous goods.
A li-ion battery pack alone falls below the appli-
cable limit value and certified as per UN manual
ST/SG/AC.10/11/rev. 3 part III, subsection 38.3.
However, dangerous goods regulations may ap-
ply when several battery packs are transported.
For shipping by third parties (e.g. air transport or
freight forwarding company) special requirements
with regard to packaging and labelling must be
observed. For the preparation of the package an
expert on hazardous goods must be consulted.
Please observe any further national regulations.
Only return the battery pack if the housing is
undamaged. Tape over the exposed contacts and
wrap the battery pack so that it cannot move inside
the packaging.