Recording From Receiver Unit - Robotex AVATAR User Manual

Recording Audio/Video Files from
To start recording:
1. Insert a USB flash drive into any USB port on the Receiver Unit. The
message "Recording Started" will automatically show on the screen.
2. The red dot on the icon
in progress.
To end recording:
1. Quickly press the main power button on the Receiver (
on the screen will say "Finalizing the Recording. Please Wait...". If held
down too long, the power button will turn the A/V Receiver off, so make
sure it is just a quick press of the button.
2. When the message changes to "Recording Complete," the USB device can
be safely removed.
Note: If the USB flash drive becomes full, use the method described in "End
Recording" to remove the full USB drive. Then, swap in an empty USB drive
and recording will continue.
DO NOT PULL USB FLASH DRIVE OUT OF PORT WITHOUT FOLLOWING THE
PROPER "END RECORDING" PROCEDURE. FAILURE TO DO SO WILL RESULT IN
CRITICAL VIDEO DATA DAMAGE. VIDEO WILL BE LOST AND IRRETREIVABLE
10
Avatar Audio/Video Receiver User Manual
Receiver Unit
will start flashing, indicating recording is
). The message
V2 10/2015