Cassette Recorder; Cassette Playback - Philips AQ5130/93 User Manual

Stereo radio cassette recorder
Table of Contents

Advertisement

Cassette Recorder

Cassette playback

1 Push the Source selector to TAPE
2 Press STOP•EJECT 9/ to open the
cassette holder and insert a cassette and
close the deck.
3 Press PLAY 1 to start playback.
4 To pause playback press PAUSE ;.
To resume, press the key again.
5 By pressing F.FWD/REWIND 5 or 6,
fast forwading/ rewinding of the tape is
possible in both directions. To stop fast
winding, press 9//.
6 To stop the tape, press 9//.
Helpful hints:
During playback, the keys are automatically
released at the end of a tape and the set is
switched off (unless PAUSE ; mode has been
activated.)
During fast forwarding/rewinding, the keys will
not be released at the end of a tape. To switch
off the set, make sure the cassette keys are also
released.
The making of unauthorized copies of
copy-protected material, including com-
puter programmes, files, broadcasts and
sound recordings, may be an infringe-
ment of copyrights and constitute a
criminal offence.This equipment should
not be used for such purposes.
General information on recording
Recording is permissible insofar as copyright
or. other rights of third parties are not
infringed.
For recording, use only NORMAL type
cassettes (IEC type I) on which the tabs have
not yet been broken.This deck is not suited
for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes.
The best recording level is set automatically.
Altering the VOLUME will not affect the
recording.
To protect a tape from accidental erasure,
break out the tabs. If you wish to record again,
cover the tabs with a piece of adhesive tape.
Recording from the Radio
1 Select RADIO source.
2 Tune to the desired radio station (see Radio
reception).
3 Press 9// to open the cassette holder.
Insert a blank tape and close the deck.
4 Press REC 0 to start recording.
5 For brief interruptions press ;.
To resume recording, press ; again.
6 To stop recording, press 9//.
Making your recording
1 Select TAPE source.
2 Follows steps 3-4 under Recording from
the Radio.
3 Speak towards the built-in microphone
MIC (see 1).
4 Follows steps 6-7 under Recording from
the Radio.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aq5130

Table of Contents