Subscribe to Our Youtube Channel
Summary of Contents for VictoriaPlum 3060-L-6080
- Page 1 RECTANGULAR MIRRORS 3060-L-6080 3061-L-5070 3121-L-5070 3095-L-6080 3060-L-3950 3120-L-3950 3096-L-8060...
- Page 2 BEFORE YOU START, HERE IS SOME IMPORTANT INFORMATION. 1) General Information Please inspect this product upon delivery. Any missing parts or manufacturing defects must be reported immediately to the supplier. Damage or defects reported later will not be accepted. TAKE CARE WHEN HANDING GLASS PARTS- AVOID HEAVY CONTACT BETWEEN THE GLASS EDGES AND ANY HARD SURFACE.
- Page 3 Parts Image Tape Measure Drill Cross Head Spirit Level Screwdriver Ø8mm Drill Bit Pencil ASSEMBLY DRAWING 3060-L-3950 / 3060-L-6080 3120-L-3950 / 3121-L-5070 Demister pad Demister pad 2 IR motion sensor 2 IR motion sensor 3 LED driver 3 LED driver 3061-L-5070...
- Page 4 INSTALLATION STEPS STEP 1 ISOLATE THE MAINS POWER SUPPLY TO THE ELECTRICAL FEED THAT WILL POWER YOUR MIRROR. STEP 2 Do not stand the mirror upright on hard surfaces whilst fitting, as this will damage the corners. Unscrew the front of the mirror from the metal back box. STEP 3 Put the back box on the wall, ensuring your power supply cable will reach the connection block.
- Page 5 STEP 5 Insert the wall plugs and fix the back box to the wall using the screws provided. NOTE: As the mounting surfaces vary, please ensure adequate fixings are used. Fixings supplied are not suitable for all mounting surfaces, e.g. plaster board. STEP 6 Wire the main power supply to the terminal block on the back box as belows.
- Page 6 STEP 7 Screw the front mirror to the back box using the screws provided. STEP 8 Peel off the protective film from the mirror and clean with a soft cloth. STEP 7 Bluetooth Wireless Technology Operation Guide • The Bluetooth is always activated w hen the mirror is connected to the main power supply, which ensures your device can connect to the Bluetooth even if the lights are turned off.
- Page 7 CARE AND MAINTENANCE 1) AFTER CARE INSTRUCTIONS It is recommended that mirrors are cleaned with a soft, dry, non-abrasive cloth. Do not use abrasive cleaning materials, or chemical cleaners as this will damage the mirror surface and edges. 2) MAINTENANCE The supplier accepts no liability for any type of use of care other than those contained in this instruction.
Need help?
Do you have a question about the 3060-L-6080 and is the answer not in the manual?
Questions and answers