Pulsed Harmonix True Pulse A2000 Quick Start Manual

IMPORTANT. DO NOT attempt to remove
AC power cord from the back of the A2000.
Doing so may void the warranty.
Connecting the device
1
1.
Mat
Mitt
Pulsed Harmonix offers the ability to operate two
accessories applicators from a single TruePulse
A2000 PEMF wellness device
Junction
See website for Dual Applicator Quick Start Guide
barrel
Groove
Image 1
Insert groove into
grove opening
3.
Turn on and set session intensity.
and intensity levels on the front of the A2000. See next page for instructions. To REMOVE connector, press down
and slide the silver metal locking tab back and away from the A2000.
True Pulse A2000
Connect device to wall.
Press the "Reset" button on the GFCI
(Ground Fault Circuit Interrupter) as shown.
There is an audible snap when the GFCI is
engaged. Press "Test" and then "Reset".
Pouch
Image 2
Push connector in
towards the device
Turn "on" power switch on the back of the device and set the desired time
Quick Start Guide
®
Turn on power switch
3
Connect applicator connector
See how to connect applicator correctly below.
2A.
Choose an applicator coil
plug the connector receptacles on the back of the A2000.
2B.
Connecting the connector receptacles.
connectors, make sure the connector with the red dot is
plugged into the socket with the red dot. Shown on "Image 4"
Image 3 Image 4
3
Turn clockwise until Same procedure for
you hear a "click" red-dotted connector.
See green arrows on image 4
2
(mat, mitt or pouch) and then
Each coil has 2
Red dot
2
1
Connector
red dot
Make sure the red
dot connector, is
plugged into the
red dot side