Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Signature SIG-34-IC
- Page 1 INSTALLATION MANUAL ARCHITECHTURAL SPEAKERS...
- Page 2 page | 2...
- Page 3 | 3 INTRODUCTION Thank you for purchasing Signature speakers by Episode. Complete the Setup, Connect, Secure, and Fine Tune sections in this manual to ensure proper installation. Visit our website for design recommendations and speaker calculators. SETUP New Construction Install Episode speaker installations can be simplified by using Episode pre-construction brackets (sold separately).
- Page 4 | 4 Cradle Installation Cradle installation is possible for all Signature series speakers. Refer to the table below for the correct cradle to use for each speaker. Cradle SIG-CRADLE-IC-4 SIG-CRADLE-IC-6 SIG-CRADLE-IC-8 SIG-34-IC SIG-36-IC SIG-38-IC SIG-54-IC SIG-36-ICDVC SIG-36-POINT SIG-56-IC SIG-58-IC...
- Page 5 Back Box and Grille Installation with Cradle The Signature cradle allows for optional installs with both the Episode Signature back boxes as well as grilles. Both of these options can be done with or without the speaker installed in the cradle. The Signature cradle allows for quick and tool-free installation when mounted to the back box.
- Page 6 page | 6 Cutout Dimensions Refer to the chart below to verify the correct dimensions prior to cutting drywall. Model Finished Cutout Dimension Mounting Depth Mounting Dimension No Enclosure Depth with Enclosure IC-4 7.5" 6.2" 4.6" 5.9" IC-6* 9.6" 8.3" 4.8"...
- Page 7 page | 7 CONNECT Strip the insulation on each conductor approximately ¼” and insert into the speaker terminals. Ensure no strands of wire protrude from the connectors. Observe proper polarity for each speaker to the amplifier (+ to + and – to – ). Refer to the dual voice coil speaker wiring configuration image below when wiring a dual voice coil speaker.
- Page 8 page | 8 Tighten 1. The speaker is now held in place, freeing up your hands so that you may continue to tighten the dogs safely. 2. While the speaker can be installed without tightening, the push lock dog system allows the speaker to be cinched tight by up to 6mm.
- Page 9 | 9 INSERTING AND REMOVING THE SPEAKER FROM THE CRADLE Signature speakers can be installed as either a 1 or 2 piece system. Signature speakers ship as a single assembled unit for easy 1 step installs, but can be separated before install. This section describes how to separate the speaker from the cradle as well as insert it.
- Page 10 page | 10 FINE TUNE Adjust the Tweeter Remove protective cover before playing the speaker. The protective cover is in place to protect the speaker from paint and dust during the install process. There are four different types of tweeter mechanisms illustrated below that may be used depending on the type of speaker.
- Page 11 page | 11 Adjust the sound Use the switch on the face of the speaker for sound adjustment. Switches can vary by model. Treble/Bass Switch: ‒ Select NOTE: The default setting is +2dB. In furnished rooms, it is recommended to set to + to increase response by +2dB.
-
Page 12: Warranty
WARRANTY Lifetime Limited Warranty Episode® speakers have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to products that have been abused, modified or disassembled.
Need help?
Do you have a question about the SIG-34-IC and is the answer not in the manual?
Questions and answers