Advertisement
1
Introduce the sling by sliding it down between
the chair backrest and the person's back until
the top of the commode aperture reaches the
base of the spine. If the sling can not be
introduced from behind, apply the sling in a
position level with the person. Leave the sling
half way down the persons back (at this stage
don't bring the sling to shoulder level).
3
Important - At the base of the leg section strap
there is a loop. Bring the straps together by
passing one strap through the loop.
Now raise the top of the sling level with the
person's shoulders. The fitting of the sling is
now complete
Important - always peel the sling away from the person to avoid skin friction and movement.
HOW TO FIT FROM SEATING POSITION
PL1 - Prism Universal User Guide - Doc 001 - Rev 10/2010
Hoisting from a chair
Note: The person to be transferred shall be referred to as "the person".
To remove the sling, carry out the fitting procedure in reverse.
Bring the leg sections along-side the person's
thighs and pull lightly to ensure that they are of
equal length.
Using good manual handling
techniques, block the persons leg to stop them
from moving forward whilst the sling is being
pulled into position. Raise the persons leg and
feed the leg sections under the person's
thighs. Ensure the sling is not twisted or
creased underneath the thighs.
The six straps should now be attached to
the carry bar hooks. Raise the carry bar
just enough to tension the straps and
ensure that they are still securely attached.
The person can now be lifted as required.
2
4
Advertisement
