Heat Inside HEATWAVE Quick Start Manual

SAFETY FEATURES

The FabRoc heating system has been designed for safe and
®
reliable use. It has been tested to comply with European safety
regulations and the power system has been CE marked. Safety
devices are included to ensure the unit is rendered safe, even
under fault conditions.
DO NOT replace or interfere with the electrical components in
your belt or the power pack and charger unit.
The HeatWave belt, including portable power pack, is not
designed to be used under water. In addition, the portable power
pack must not, under any circumstances, be immersed in water
as this can cause electrical faults.

CLEANING INSTRUCTIONS

Remove power pack
Hand wash in warm water
Use non-biological soap powder
Rinse thoroughly
DO NOT TUMBLE DRY OR DRY CLEAN

WARRANTY

Every EXO2 garment is supplied with a one-year warranty
covering all electronic and mechanical failures. In the unlikely
event that any part should fail within the first year, return it to us
and we will repair or replace it free of charge.
Note: the warranty does not cover intentional alterations,
accidental damage or improper cleaning.
If using this product with the EXO2 heat controller...
remove the metal backing plate of your controller as this will
invalidate your warranty even if refitted later as the water seal
will have been breached. (P25S13 adaptor required for using
with heat controller).

TROUBLESHOOTING

What happens if my HeatWave belt doesn't get warm?
Firstly, check that you have the HeatWave belt connected to a
power source, either via the motorcycle power cable or via the
optional power pack.
If you have your HeatWave connected via the motorcycle power
cable, check that the cable is correctly fitted to your bike battery.
In addition, check that the motorcycle power cable is correctly
fitted to the cable that connects to the FabRoc
the P13S13 extension cable if used). The heat panel cable can
be found in the power pack pocket of your HeatWave.
Ensure the portable power pack is charged. This can be done
by firstly plugging the power pack into the associated charger.
If the red light on the charger comes on and stays on, the power
pack needs to be charged. If the power pack is charged, check
that the belt plug is correctly attached to the powerpack.
Should you have any questions about your heated products,
please contact:
Customer Services Dept
EXO2
Caledonian House
Phoenix Crescent
Strathclyde Business Park
Bellshill ML4 3NJ
Tel: +44 (0)1698 746347
Email: sales@exo2.co.uk
Never
heat panels (or
®
HEATWAVE
www.exo2.co.uk
Heated back support/belt
for motorcyclists