BioBrite EZ Wake SunRise Instructions

Replacing the Bulb

To replace the bulb (use only a 60 Watt bulb), first unplug the clock from the wall. To replace the bulb (use only a 60 Watt bulb), first unplug the clock from the wall.
Remove the globe from the clock by pulling upward. Remove the globe by Remove the globe from the clock by pulling upward. Remove the globe by
holding the base with one hand, and pulling up on the globe. Take care not to holding the base with one hand, and pulling up on the globe. Take care not to
break the bulb by hitting it with the globe as you do this. Caution
was recently in use, it will be hot -- let the lamp cool before removing the bulb.
Screw in the new bulb completely. Carefully put the globe back on by lowering it Screw in the new bulb completely. Carefully put the globe back on by lowering it
over the bulb (the slots on the globe face backwards) and make sure it is fully the globe face backwards) and make sure it is fully
home and securely held. Plug in the clock, re-set the time, alarm time, and any
other settings. other settings. Replacement bulbs are available from BioBrite or local Replacement bulbs are available from BioBrite or local
hardware stores (ask for a 110 Volt 60 Watt E12 Candelabra base frosted bulb).

Warranty

The EZ Wake SunRise Clock is guaranteed against any defect in its manufacture The EZ Wake SunRise Clock is guaranteed against any defect in its manufacture
for 12 months from the date of purchase.

Service

If your EZ Wake SunRise Clock requires service, please remove the globe and If your EZ Wake SunRise Clock requires service, please remove the globe and
bulb and package the base with a note containing: your name, the address to ckage the base with a note containing: your name, the address to
which it should be returned after servicing, a daytime telephone number, a which it should be returned after servicing, a daytime telephone number, a
description of the problem(s) you are experiencing and send it to: BioBrite description of the problem(s) you are experiencing and send it to: BioBrite
Service Department, c/o Saville Electronics, 2613 Joppa Terrace, Baltimore, MD
21234. If your clock is more than 12 months old, include a $25.00 check made 21234. If your clock is more than 12 months old, include a $25.00 check made
payable to "BioBrite, Inc.". If newer, the repair is covered by the warranty. payable to "BioBrite, Inc.". If newer, the repair is covered by the warranty.
WARRANTY FORM
NAME _______________________________________________________ _______________________________________________________
ADDRESS ____________________________________________________ ____________________________________________________
____________________________________________________ ____________________________________________________________
TELEPHONE__________________________________________________
DATE & PLACE OF PURCHASE __________________________________
MODEL/SERIAL NO. ___________________________________________ ___________________________________________
Caution: If the bulb
let the lamp cool before removing the bulb.
set the time, alarm time, and any
andelabra base frosted bulb).
onics, 2613 Joppa Terrace, Baltimore, MD
________________
__________________________________
-3-
INSTRUCTIONS INSTRUCTIONS
FOR THE FOR THE
EZ WAKE EZ WAKE
S R C
UN ISE LOCK LOCK
4330 East-West Hwy.Suite 310
   
BioBrite, Inc
.
Bethesda, MD 20814
301-961-5940
Email: biobrite@aol.com
Website: www.biobrite.com