ShoreTel BB424 Quick Install Manual

Adjusting the Viewing Angle of the BB424
(Optional)
The stand on the BB424 supports two tilt angles so that you can adjust how the button box sits
on a desk. The stand is shipped in the low position, which is the recommended position. If you
prefer the stand to be in the high position, use these instructions to change the tilt angle.
Remove the Stand:
① Disconnect any cables from the back of the BB424.
② Grasp the BB424 base in one hand and the stand in the other.
③ Pull the stand off the base until it unsnaps.
Low angle
3
2
Replace the Stand:
① Rotate the stand 180 degrees. Seat the stand firmly in the hooks.
② Push the stand into the base until it snaps into place.
③ Reattach cables.
High angle
2
1
Refer to http://www.shoretel.com/products/ip_phones for more information.
4
ShoreTel, Inc. l www.shoretel.com
Part Number: 800-1891-01
ShoreTel BB424
Quick Install Guide
Connecting a Single BB424 to a Phone
Required Items:
500 mm micro USB cable (included). If you want to position the BB424 farther from the phone, use
l
a standard USB cable.
ShoreTel IP485g phone
l
Connect the BB424 to the Phone:
① Ensure that the host ShoreTel IP485g phone is powered on and running.
② The BB424 is shipped with the micro USB cable already plugged into the back of it. Ensure that it
is plugged in firmly.
③ Thread the free end of the micro USB cable from the side of the BB424 stand through the side of
the ShoreTel IP485g phone stand. Plug the USB jack into the USB port on the rear of the ShoreTel
IP485g phone.
After a few seconds, the BB424 powers on and runs through a series of system tests. The BB424 auto-
matically updates to the firmware version of the host phone.
2
3
1