Table of Contents
Advertisement
To Fill The Fuel Tank:
1.
IMPORTANT! Your warranty is voided if:
You do not operate the Chain Saw with the proper 25:1 fuel mix in its
Fuel Tank. Never run the Engine with an improper fuel mix, low or no fuel mix.
Running the Engine with an improper fuel mix, low or no fuel mix will
permanently damage the unit. (See Figure D.)
2.
To obtain the proper 25:1 fuel mix, combine 25 parts unleaded gasoline with 1
part 2-cycle oil in a clean, approved container. Cover and shake to thoroughly
mix before each fueling. NOTE: Mix only enough fuel for a few days work. The
maximum storage time of mixed fuel is three months.
3.
Once the proper fuel mix is obtained, turn the Chain Saw on its side with its Fuel
Tank Cap (57) facing up. Unscrew and remove the Fuel Tank Cap. Fill the Fuel
Tank approximately 3/4 full with the fuel mix (the Fuel Tank capacity is
approxiately 18.6 ounces). Then, replace the Fuel Tank Cap. (See Figure D.)
4.
WARNING! NEVER attempt to fill the Fuel Tank when the Engine is running
or hot to the touch.
FIGURE D
The Chain Brake:
1.
WARNING! Always wear safety equipment. When operating the Chain
Saw, always wear ANSI approved safety impact eye goggles, hearing protection,
heavy duty work gloves, sturdy work boots, and head protection.
2.
IMPORTANT: This Chain Saw is equipped with an automatic Chain Brake (28) to
stop Saw Chain (77) rotation in the event of an emergency such as kickback
while in a cutting operation. (See Figure E, next page.)
SKU 95497
For technical questions, please call 1-800-444-3353
OPERATING INSTRUCTIONS
FUEL TANK CAP (57)
PAGE 11
Advertisement
Table of Contents
