Troubleshooting - Philips AJ3280/00 Instructions For Use Manual

– If a fault occurs, first check the points listed below before taking the set for repair.
– If you are unable to remedy a problem by following the hints below, consult your dealer or service
centre.
WARNING:
under no circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
Problem
– POSSIBLE CAUSE
• REMEDY
No sound
– Volume not adjusted.
• Adjust the volume.
MW (or LW) broadcast cannot be received
properly
– Weak radio signal.
• Rotate the set for better reception and make
sure the set is placed on a non-metallic
surface.
Continuous crackling and hiss noise during
MW (or LW) reception
– Interference from other electrical equipment
e.g. TV's, computers, fluorescent lamps.
• Move the clock radio away from electrical
equipment.
Environmental information
All redundant packaging material has been omitted. We have done our utmost to make the
packaging easily separable into three mono materials: cardboard (box), expandable polystyrene
(buffer) and polyethylene (bags, protective foam sheet).
Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the disposal of
packaging materials, exhausted batteries and old equipment.
This product complies with the radio interference requirements of the European Community
Both the model and production numbers can be found on the bottom of the set.

TROUBLESHOOTING

Intermittent crackling sound during
FM reception
– Weak signal.
• Adjust the pigtail aerial.
The alarm does not function
– The alarm is not set
• Set the alarm time and the alarm switch to
or .
BUZ RAD
– Volume too low for radio.
• Increase the volume.
The SLUMBER does not function
– RADIO still in ON position.
• Switch RADIO to OFF position.
AJ3280/00 page 7
7