Page 1
User Manual Multifunctional Car Jump Starter Thank you for choosing TACKLIFE KP120 smart car jump starter. Please read the user manual carefully before use and keep it for further reference. A. Configurations: 1. Electricity Indicator 2. 12V Jumper Cable Interface 3.
Page 2
Press the power switch, and the indicators will show electricity as follows: Electricity None Three Four Indicators KP120 100% Electricity The blinking light bar indicates how much electricity has been charged during charging. All lights will go off when it is fully charged. C. Instructions Steps to recharge the unit 1.
Page 3
Steps To Jump Start Vehicles(12V Only) 1. Plug the blue end of Smart Jumper Cable into the 12V Jumper Cable Interface on the unit 2. Connect the clamps to the vehicle battery. Red clamp to positive polarity(+), black clamp to negative polarity(-) 3.
Page 4
Steps to charge your electronics 1. Connect your phone/tablet or other devices with the unit by USB cable. 2. Press the Power Switch on the unit, and the unit will have a tailored, high- speed charge to your devices. Steps to power other 12V auto products. 1.
Page 5
A1: The product has a smart detection function. Once there is no load or the electronics is fully charged, it will automatically shut down to save power. Q2: How long does it take to recharge KP120 fully? Q2: Approximately 3~4 hours.
Page 6
A5: In regular use, it can work for 2~3 years. Q6: How long can it hold a charge? A6: The circuit design of KP120 is very scientific. It can hold a charge for 6~12 months, but to extend the service life and be prepared for an emergency, we...
Page 7
G. Troubleshooting If the following “actions” cannot troubleshoot your failure, please stop using the KP120 and contact the seller who you purchased the product from. Case Cause Solution The KP120 does not respond The circuits are cut off by Recharge the unit at least...
Page 8
6. Prohibit using it as a car battery charger. 7. Please remove the unit from your car battery in time after cranking your car successfully. 8. Please use the equipped jumper cables, and other accessories come with it only. 9. Please make sure that the blue end of the jumper cable is fully inserted into the jumper cable interface.
Page 9
18. Do not immerse the product in water. 19. Do not operate the product in an explosive atmosphere like the presence of flammable liquids, gases, or dust. 20. Do not remodel or disassemble the product. Only professional technicians are allowed to repair. 21.
Page 10
minutes and seek medical attention immediately. 30. Lithium-ion battery-based products should be disposed of under local regulations at the end of their life. Not all 12V auto products are compatible with this unit. At present, it can only supply power to some small-sized automotive electronic products, such as portable electric tire inflator.
Need help?
Do you have a question about the KP120 and is the answer not in the manual?
Questions and answers
kp 120 blinks blue light 7 times and goes off does not charge up