How To Operate Your Hand Vacuum; Motor Thermostat; Changing & Cleaning The Dust Cup Filter - Euroflex Mini Monster 030 Instruction Manual

HOW TO OPERATE YOUR HAND VACUUM

1. Hold the hand vacuum firmly with your hand on the handle (4).
2. Push the ON/OFF Power Switch (3) to "I" position.
3. Start vacuuming.
CAUTION: The Hand Vacuum is a very powerful unit. Make sure that you hold it firmly, otherwise it can
slip out of your hand and cause injury.

MOTOR THERMOSTAT

IMPORTANT: The motor of this appliance is equipped with a safety thermostat. Should the hand vacuum
overheat, the thermostat will automatically shut off the motor. If this occur, switch off the appliance by
turning the Power Switch (3) to O position and unplug the appliance. Wait for the appliance to cool down
for some minutes and then restart vacuuming.
CHANGING & CLEANING THE DUST CUP FILTER
Warning: Always unplug from electrical outlet before opening the dust cup (container) (5).
1. To open the dust cup (container) (5), push button (2) and pull out the dust cup (5), (fig. 1).
2. Pull out the Dust Cup Filter (6), (fig. 2).
3. Empty the dust from the Dust Cup Filter (6).
4. Rinse the Dust Cup Filter (6) in cold water. Wait until it dries up before replacing it into the Dust Cup
(container) (5).
5. Place the Dust Cup Filter (6) carefully into the Dust Cup (container) (5).
6. Attach the Dust Cup (container) (5) to the Hand Vacuum.
fig.1 fig.2
CAUTION: The suction hole (1) must be open, free of any obstructions at all times. Otherwise, the motor
will overheat and could get damaged.
15