Download Print this page

Sealey CH2800.V2 Instructions page 2

Standing ceramic heater 1.4/2.8kw 230v

Advertisement

warning! if supply trips at consumer unit, ensure correct rating of supply and appliance. if further tripping occurs consult a
qualified electrician.
dO nOt place any object on the safety guard of the heater cassette at any time.
8
warning! Ensure the heater is at least 2m from any object.
dO nOt leave unattended.
8
warning! This heater is not equipped with a device to control the room temperature. dO nOt use this heater in small rooms when they
are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
When not in use, store the heater carefully in a safe, dry, childproof location.
9
nOte: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.
nOte: Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or
installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
2. intrOductiOn
Powder coated metal construction with two ceramic heating elements providing instant heat when required. Ideal for workshops and garages.
Features chemically polished reflectors to provide maximum heat emission. Controllable power output with rocker switches on the side of the unit.
Fitted with sturdy frame and carry handle. Supplied with cable and BS1363 approved plug.
3. speciFicatiOn
model no .................................................................CH2800S
max. height .............................................................. 1760mm
min. height ............................................................... 1500mm
Weight ........................................................................... 8.1kg
Power .................................................................1400/2800W
Supply .................................................................. 230V - 13A
fig.1
4. OperatiOn
warning! Ensure you read, understand and apply the safety instructions in Section 1 before using the heater.
nOte! The ceramic element is fragile and therefore it is important that it is not subjected to any unnecessary shocks or vibration and
is not moved when it is on or until cooled down. during relocation the heater should be switched off and disconnected from the power
supply. Ensure the heater is at least 2m from any object.
4.1.
Plug in the heater and switch it on.
4.2.
The heater has a switch for each element.
4.3.
When the heater is no longer required, switch off and unplug the unit.
4.4.
In the event of the heater being knocked over, a safety cut-out switch, which activates at an angle of 35º ±10º, will disable the heater.
4.5.
Follow these steps to re-start the heater.
a)
Switch 'off' the heater.
b)
disconnect the power cord from the power supply.
c)
Return the heater to a standing position.
d)
If no damage has occurred to elements, replace safety guard if applicable, re-connect power cord to the power supply and
switch the heater back on.
4.6.
Should the power cord require replacement, a complete wiring loom should be purchased and fitted by a suitably qualified person.
© Jack Sealey limited
Original Language Version
3.1.
iOn
CH2800.V2| Issue:3 (H,F) 02/05/18

Advertisement

loading