Advertisement
Quick Links
IN ROLL TUBE CABLE RETURN
Use these instructions to install an in roll tube cable return on 2 or 3" roll tube. Read
and follow these instructions along with the standard instructions carefully before
installing or using tarp system.
NOTICE TO INSTALLER: Even if familiar with hardware, read instructions prior to
installation as improvements may be made without notice. Always handle components
with care. If you have questions or problems, call customer service. When done, these
instructions must be given to the consumer.
NOTICE TO CONSUMER: Before using this product, read special instructions. Save
these instructions for future reference.
Questions? 800-233-4655
agricover.com
Advertisement
Summary of Contents for aci 80493_E
- Page 1 IN ROLL TUBE CABLE RETURN Use these instructions to install an in roll tube cable return on 2 or 3” roll tube. Read and follow these instructions along with the standard instructions carefully before installing or using tarp system. NOTICE TO INSTALLER: Even if familiar with hardware, read instructions prior to installation as improvements may be made without notice.
- Page 2 PREPARATION COMPONENTS TOOLS NEEDED • Return assembly with hardware • Drill with 5/16” bit • Guide with hardware • 9/16” Socket and wrench • End plug with hardware • #2 Phillips head driver • Adhesive packet • Rubber mallet • Marking pen •...
- Page 3 2: INSERT RETURN ASSEMBLY NOTE: Remove any existing returns. Unroll tarp to hang down on latch plate side. Install return on non-drive side (opposite side of tarp motor or crank handle). Perform one of the following to install return assembly, then proceed to Step 3: ALUMINUM ROLL TUBE A.
- Page 4 Fasten guide with (2) 3/8” x 1” self-threading hex bolts. 1/2” Guide Latch plate 3/8” x 1” Self-threading hex bolts B. Open and close tarp several times. Make adjustments in knot location if needed. Path of cable Cable Product subject to change without notice. 121019 80493_E...