Arbiter Systems 1094B Setup Manual

1094B SETUP GUIDE
Unpacking
Carefully check the packing material for these accessories: GNSS antenna, standard antenna cable
assembly, and two rack-mount ears. Handle the GNSS antenna with care. It may be damaged if dropped.
Configuring Output Jumpers
Remove the four M5 10 mm pan head screws securing the clock cover. Some output signals require two
jumpers. Example: 5 volt CMOS level IRIG-B Unmodulated on Output 1 requires JMP10=A and JMP11=C.
Whereas IRIG-B Modulated on Output 1 only requires that JMP11=B.
Drive Type
CMOS, 5 V
300-V FET
Signal Select JMP10
IRIG-B Modulated
IRIG-B Unmodulated
1 PPS
Programmable Pulse A
Programmable Pulse B
Out of Lock
Fault
* Default Setting
Arbiter Systems, Inc. 1324 Vendels Circle, Suite 121 Paso Robles, CA 93446 USA Tel: +1.805.237.3831
Fax: +1.805.238.5717 E-mail: techsupport@arbiter.com Internet: http://www.arbiter.com
Figure 1: Mainboard Jumper Locations
Output 1 Output 2
JMP11
C*
A
JMP12
B
A* A*
B B
C C
Table 1: Mainboard Output and Relay Signal Selection
Output 3
JMP13 JMP15
C* C*
A A
JMP14
B B
A*
B
C
Output 4 RELAY
JMP17
C*
A
JMP16 JMP8
B
A*
B
C
C
A*
B
PD0052800B 1