nologo CARTY-R Quick Start Manual


Compatible remote control, code remote control.

It memorizes four different codes one button each.
1
2
4
3
CLONE THE FIX AND ROLLING CODE WITHOUT THE SOURCE CODE
All rolling code remote or fix code in the list which can be downloaded in the web site,
excluding the remote controls with the source code, see next paragraph.
5 - Press and release the button to be copied in the remote and wait for a while until the led CARTY-R is
flashing quickly to confirm the correct learning copy process.
6 - While the LED flashes (max 20sec.), press and keep press the corresponding button on CARTY-R
where you need to copy the original code until the LED switched off to confirm the right
learning copy process.
IN THE RADIO RECEIVER
Choose "MODE" in the table:
CLONE THE ROLLING FAAC / GENIUS
FAAC
433 / 868
The remote control must be a MASTER, if you press the button the LED flashes twice instead fix light.
5 - Press and keep pressed the button to be copied until the Led of CARTY-R lits on.
6 - Release the button and wait.
7 - LED of CARTY-R flashes shortly each 2sec.
This indicate that it is time to memorize the
8 - Press simultaneously buttons 1 and 2 of FAAC or GENIUS remote control and release them
9 - LED of the remote control FAAC or GENIUS flashes (max 9sec.)
10 - Press and keep pressed the button to be copied of FAAC or GENIUS remote control and wait for a
few seconds until the LED CARTY-R flashes quickly.
11 - Press the button which need to be copied and keep pressed
until the LED of CARTY-R switched off.
IN THE RADIO RECEIVER
Check the right function of the new remote control CARTY-R
See MODE FAST or
INITIALIZING
1 - Place the original remote control X in front of CARTY-R at 4 cm of distance
2 - Press and keep pressed button
3 - Press four times the button
4 - Release all buttons
Red LED flashes shortly every 2,5 sec.
(8 flashes) for maximum 20sec. which.....
MODE FAST or
WITH THE SOURCE CODE
GENIUS
433 / 868
MODE ENTER pressing twice the memorized button.
CARTY-R
1 the LED is
2 and the led will be
MODE ENTER or MODE MANUAL
source code.
green
red