Carefree of Colorado RV SIDE-OUT SOKII Series Replacement Manual

RV Kits
T
HESE PROCEDURES DEAL DIRECTLY WITH THE PRE
FAILURE TO FOLLOW THE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY AND
SOKII C R
ANOPY EPLACEMENT
R O F
EMOVING THE LD ABRIC
1. Open the slide out room 10"-12".
2. Remove the screws and end caps from the pivot brackets and set
aside.
3. Remove the screws and deflector or full case and set aside.
4. Remove the fabric retaining screws from the awning rail. Do not
discard.
5. On the left side of the rollbar align the holes in the rollbar with the
holes in the pivot bracket inside the rollbar. It may be necessary
to rotate the rollbar to align the holes.
6. Insert the furnished 2 inch cotter pin through the holes. Insert the
pin as far as possible.
7. (See Figure 1) Grasp the roll bar and loosen the spring attach bolt on
the outside of the LH pivot bracket. Loosen only 2-3 turns,
. The rollbar can now spin freely.
REMOVE
NOTE: When rotating the roll bar the bolt may have a
tendency to tighten. Loosen as needed.
8. Unroll the fabric off of the roll bar by rotating the roll bar toward the
coach.
9. (See Figure 2) Holding or supporting the
bar; remove the attaching screws and remove the
bracket from the mounting bracket and roll bar and set aside.
10. Simultaneously slide the fabric to the right from the awning rail and rollbar.
I N F
NSTALLING THE EW
11. Check that the awning rail and roll bar grooves are clean. If necessary spread open the end of the awning rail slightly;
deburr the awning rail. Lightly spray the inside of the awning rail and roll bar grooves with a silicone lubricant.
12. Carefully insert the new fabric into the awning rail approximately 6 to 8 inches. The edge with the larger polyrod
goes into the awning rail.
13. Carefully insert the new fabric into the roll bar groove. The edge with the smaller polyrod goes into the roll bar.
14. Simultaneously slide the new fabric into the awning rail and roll bar until the fabric is centered in the roll bar.
15. Insert the right pivot bracket into the roll bar and mounting bracket. Secure with the screws removed previously.
16. Slowly roll up the fabric onto the roll bar. Ensure that the fabric is rolling straight. Adjust the fabric position as required.
17. After the fabric has been rolled up, tighten the spring attach bolt on the outside of the LH pivot bracket.
18. While firmly holding the rollbar remove the cotter pin. Slowly allow the spring to take up any slack in the material
and apply tension.
19. Replace the fabric retaining screws in the awning rail.
20. Install the defector or full case.
21. Install the end caps.
052950-001r1
-
WOUND SPRING TENSION IN THE ROLL BAR
RIGHT
ABRIC
S -O C
IDE UT ANOPY
These instructions are for canopy replacement only for
•
SOKII
•
S
UMMIT
•
A & E S
WARNING
Fabric Retainer
Screws (2)
DO NOT
end of the roll
pivot
RIGHT
1
C
R
EPLACEMENT
/
W DEFLECTOR OR FULL CASE
; ,
AND
T
LIDE OPPER
. F
AILURE TO EXCERCISE CARE AND
/
OR PROPERTY DAMAGE
Cotter Pin
to Lock Spring
Roller Spring
Attach Bolt
Figure 1.
RH Pivot Bracket
Pivot Bracket
Retaining Screws
(2 per bracket)
Figure 2.
AREFREE
;
/
OR
.
SOK2022
SOK2022a
June, 2005