VelLight LEDC27 User Manual page 5

7.2 Pairing the Remote Control to Several Dimmers
One remote can also be used to control several dimmers simultaneously. To
do so:
1. Remove the power supply to the dimmer, and reapply the power
supply after 5 seconds.
2. Wait for 5 seconds, aim the remote control to the dimmer.
Simultaneously hold [on-off] and [MODE+] pressed for 5 seconds.
3. The dimmer will recognize any remote control.
7.3 Colour Sequence
To change the default output signal:
1. Remove the power supply to the dimmer, and reapply the power
supply after 5 seconds.
2. Wait for 5 seconds, aim the remote control to the dimmer.
Simultaneously hold the red and blue keys pressed for 5 seconds.
The output sequence will switch between six possible combinations.
8. Cleaning and Maintenance
This controller does not need any particular maintenance. Occasionally wipe
the controller with a damp cloth to keep it looking new. Do not use harsh
chemicals, cleaning solvents or strong detergents to clean the detector.
9. Technical Specifications
power supply .......................................................12-24 VDC
maximum load .......................................................... 3 x 2 A
PWM frequency ...................................................... ± 190 Hz
RF frequency .......................................................... 433 MHz
dimensions
RF remote ................................................. 86 x 40 x 7 mm
LED dimmer............................................... 31 x 13 x 8 mm
weight ........................................................................ 25 g
V. 01 – 04/04/2016
LEDC27
5 ©Velleman nv