Table of Contents
Advertisement
Quick Links
AS80RE11
Wireless Keyfob
Installation Instructions
General Introduction
The Wireless Keyfob is used to Arm, Partial Arm and Disarm the system. The
Keyfob also incorporates a Panic switch that will immediately initiate a Full Alarm
condition when the system is Armed or Disarmed.
Product Overview
A LED indicator
B Arm
D Disarm
E Panic Switch
G Negative Polarity
H Positive Polarity
Binding
1. Remove the battery cover behind the keyfob.
2. Prepare the CR2032 coin cell battery by removing any plastic wrapping on the
battery. Do not insert the batteries yet into the unit.
3. Log into the ELRO Smart Home Alarm account from a web browser.
C Partial Arm
F Key Chain Ring
1
4. Select "System", then "Add a New Device".
5. Select "Keyfob".
6. The following screen will appear. This means the gateway is entering binding
mode.
Advertisement
Table of Contents
Related Manuals for ELRO AS80RE11
Summary of Contents for ELRO AS80RE11
-
Page 1: Installation Instructions
1. Remove the battery cover behind the keyfob. 2. Prepare the CR2032 coin cell battery by removing any plastic wrapping on the battery. Do not insert the batteries yet into the unit. 3. Log into the ELRO Smart Home Alarm account from a web browser. - Page 2 4. Slide the Panic Switch and hold for at least 3 secs before releasing. See if there is an entry in the LOGS page of your ELRO Smart Home Alarm account. Note: Press the Disarm button to deactivate a triggered alarm and siren sound.
-
Page 3: Specifications
Maintenance Specifications Low Battery: When the battery becomes low, the LED will turn orange after Battery CR2032 3V/230mAh each press to indicate low battery condition to the user. Replace the battery Operating Frequency 868MHz Operating Temperature -10°C to 40°C when this occurs. RF Output power <...
Need help?
Do you have a question about the AS80RE11 and is the answer not in the manual?
Questions and answers