Nexa WMR-3500 Quick Start Manual

Wireless Receiver Module for Wall Outlet
A high power (16 A) receiver module that is relatively easy to fit behind an
existing wall outlet in order to turn the entire wall outlet into a wireless On/Off
function. Can be controlled by all self learning transmitters in System Nexa and
the System Nexa Pro series.
Small and compact, suitable for permanent installation in mounting box
Why WMR-3500 is unique
The wiring of the current wall outlet is wiring the Earth / Live-in / Neutral-in
directly into the socket terminal.
This module adds another wireless feature while keeping your existing wall outlet.
The receiver module comes with 2 wires with terminal connector (Live / Neutral)
so no need to prepare additional wires during installation.
Specification

Wiring

Before commencing work, ALWAYS isolate the mains power supply and switch
off the main switch.
Strip the solid wires (rigid conductor only) at least 10mm then connect the wires
as per diagrams below, ensure terminals are properly tightened and no bare wire is
visible.
2 2.
Suitable wire size for terminal: 1.6mm to 2.5mm
Remove current AC Live-in / Neutral-in wires / Earth wires from the socket block
terminals
Connect AC Live-in / Neutral-in into terminal connector making sure it's inserted
correctly.
Tidy terminal connector and place into wall box.
Connect AC Live-out / Neutral-out into socket terminals.
！Please leave the Earth wires until step D.
Tidy wires and insert the module into wall box. Connect the earth wires into
socket earth terminal.
Connect back mains power supply.
LED indicator will light ON for 10 seconds, this is to show you that the wires are
connected correctly and power is active.
To remove wires from terminal connector, simply push back and pull out the
wires.
Each connector have 2 terminals, both terminal can be used depending on your
4