Table of Contents
NOTE: These instructions include information on how to install multiple 7 Series refrigeration units. For information on
dimensions, specifi cations, and installation of single units, please refer to the installation guide included with the appliances.
Parts Included ____________________________________________________________________________________________2
Tools Needed ____________________________________________________________________________________________2
Cutout dimensions ________________________________________________________________________________________3
Specifi cations ____________________________________________________________________________________________ 4
Anti-tip location __________________________________________________________________________________________ 7
Installation ______________________________________________________________________________________________ 10
Parts included
Heater (1)
Center Trim Brackets (2)
Center Trim (1)
Top Connecting Plate (1)
Rear Connecting Plate (1)
1/4"-20 x 3/4" Connecting Plate Fasteners (6)
#8-18 x 1/2" Heater Fasteners (3)
8-18 x 1/2" Heater Fasteners (Item 7)
Top Connecting Plate (Item 4)
1/4"-20 x 3/4" Connecting Plate
Fasteners (Item 6)
WARNING
Use two or more people to move and install appliance. Failure to do
so can result in death or serious injury.
Tools Needed
Drill (Not to be used on the leveling feet)
Drill Bits - 3" Phillips (PH2), Torx (T15 & T20)
1/4" & 5/16" Hex Drive
Rubber Mallet
3/8" Wrench
1/8" Allen Wrench
2
Heater (Item 1)
Center Trim Brackets (Item 2)
Center Trim (Item 3)