Instructions - AquaScape Pro Air 60 Operating Instructions & Maintenance Manual

Instructions

STEP 1
SET COMPRESSOR
• Set the compressor in a location near a ground fault circuit
interrupter (GFCI) rated receptacle.
NOTE: Do not submerge
the compressor in water.
We recommend placing
it in a location above
the pond's water level,
whenever possible,
to prevent water from
entering the compressor.
STEP 2
THREAD MANIFOLD
• Thread the 2-way manifold into the discharge of the
compressor. The 2-way manifold provides the option of
installing up to two separate airlines with the added benefit
of airflow valve controls.
STEP 3
ATTACH TUBING TO MANIFOLD
• Attach tubing with airline check valves to each manifold
outlet. It is recommended to use hose clamps to secure
the tubing to the manifold outlet. If installing only one
airline, close the unused valve before use.
NOTE: Installing check valves will prevent water from
siphoning back through the tubing and entering the
compressor. Failure to properly install check valves may
result in the compressor being permanently damaged,
voiding the warranty.
4
STEP 4
ATTACH TUBING TO DIFFUSERS
• Attach the other end of the tubing to the diffuser(s). It is
recommended to use hose clamps to secure the tubing
onto each diffuser.
STEP 5
SET DIFFUSERS IN POND
• Set the diffuser(s) in the pond.
STEP 6
PLUG IN COMPRESSOR
• Plug the compressor
into a ground fault circuit
interrupter (GFCI) rated
receptacle and enjoy the
benefits!
☎ ☎
US (866) 877-6637 | CAN (866) 766-3426 | aquascapeinc.com