GolfAchiever GA SIM Setup Manual

Platform

GA SIM Platform Setup Guide

Warning & Disclaimer: The sport of golf can be dangerous and improper setup and application of your Gol-

fAchiever unit can result in personal injury or property damage. USE AT YOUR OW RISK! Proper installation

and application will help to insure safety. Refer to the Platform Setup Guide for proper installation and usage. Focal-

tron assumes no liability regarding the improper installation, mishandling, or misapplication of products sold. The

installer or user is responsible for confirming proper installation and safety of application. Should there be any ques-

tions as to installation and application, Focaltron must be contacted. In no event will Focaltron be liable for any inci-

dental, special, or consequential personal injuries or property damages that arise from the use of the products sold by

Focaltron even if Focaltron has been advised of such injuries or damages. For further questions or setup assistance

contact Focaltron Customer support at: +1-408-530-8588 or support@golfachiever.com.

Platform components

Below are the components needed to successfully assemble the GA SIM platform

Large platform turf (2)

Turf for Spacer (1)

Metal Spacer (1)

Large platform rubber mat (2)

Revision B 12/8/2011

Small front turf (2)

Base Protector Left/Right (2)

GA Sim base locator (2) Screws (6)

Small front rubber mat (2)

Turf Clips (6)

Metal brackets (5)

Screws (10)

Table of Contents

Do you have a question about the GA SIM and is the answer not in the manual?

Page 1 Focaltron even if Focaltron has been advised of such injuries or damages. For further questions or setup assistance contact Focaltron Customer support at: +1-408-530-8588 or support@golfachiever.com. Platform components Below are the components needed to successfully assemble the GA SIM platform Small front turf (2) Large platform turf (2)
Page 2 Step 1 Place the two largest black mats side by side with the GolfAchiever logo facing away from your desired hitting direction as shown in the picture below. Use the supplied metal brackets to secure both rubber mats together. A total of four metal brackets should be used.
Page 3 Step 6 Install your GA Sim unit by placing it into the open base locator. Be sure to properly align the azimuth pin with the designated slot on the locator. Once the unit is in place install the green metal base protector. Removal of the front green turf will make this installation easier.