Table of Contents
Advertisement
Power Supply
2 Replace the battery door, making sure the bat-
teries are firmly and correctly in place.The set is
now ready to operate.
•
Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to burst:
•
Do not mix battery types: e.g. alkaline with car-
bon zinc. Only use batteries of the same type
for the set.
•
When inserting new batteries, do not try to mix
old batteries with the new ones.
•
Remove the batteries if the set is not to be used
for a long time.
Batteries contain chemical substances, so
they should be disposed of properly.
Using AC power
1 Check if the power voltage, as shown on
the type plate located on the
bottom of the set, corresponds to your
local power supply. If it does not, consult your
dealer or service center.
2
If your set is equipped with a voltage
selector, adjust the selector so that it match-
es with the local power supply.
3 Connect the power cord to the
AC MAINS~ inlet and the wall socket.The
set is now connected and ready for use.
4 To switch the set off completely, withdraw the
power cord from the wall socket.
5 Install the unit near the AC outlet and where
the AC power plug can be easily reached.
•
Disconnect the power cord from the wall
socket to protect your set during heavy
thunderstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.
The type plate is located on the
bottom of the set.
Helpful hints:
–
To avoid unnecessary energy consumption,
always adjust the Source selector to OFF
after using the set.
Basic functions
Switching on/off the set
1 To switch on, adjust the source selector to
CD/USB, TUNER,
2 To switch off, adjust the source selector to
OFF.
Adjusting volume and sound
Adjust the sound with the VOLUME and
DBB controls.
Radio reception
1 Push the source selector to TUNER.
2 Adjust the BAND to MW or FM to select
your desired waveband.
3 Turn TUNING to tune in a radio station.
4 To switch off the radio, adjust the source
selector to OFF.
Helpful hints:
To improve reception
For FM, extend, incline and turn the
•
telescopic antenna. Reduce its length if the
signal is too strong.
For MW, uses a built-in antenna. Direct this
•
antenna by turning the whole set.
or AUX
as desired.
Advertisement
Table of Contents
