Page 1
Schulze PRETREATMaker III Stand Parts and assembly instruction for Stand part# (PT3STAND). The stand comes in a flat box measuring 36”L x 29”W x 3.5”D. Parts included 8 Screws, 8 Screw Covers, 8 Feet Caps: Used on the top and bottom of side panels and support beams.
Page 2
2 stand side panels: The metal panels face outward when assembled and the long section of the legs are the bottom of the stand. 1 stand base: Place on the bottom of the stand with the base top facing upward after assembly, base sits freely at bottom of stand.
Page 3
Installation and assembly steps: 1. Install a screw into the side panel and support beam using a #6 metric Hex/Allen wrench (not included). Make sure it is aligned with the side panel leg and tighten firmly. Repeat this step for the top and bottom on all four support beams.
Page 4
2. Install the Screw Covers and Feet Caps. Use a rubber mallet to hammer both into the legs. You can us a regular hammer but be gentle because it may split or break the plastic covers and caps during the hammering process. 3.
Page 5
NOTE: The pretreat machine has rubber feet that will sit on the inside of the stand “Top Brackets” and the base of the pretreat machine will sit flush on the top “Feet Caps”. Be careful moving and handling the pretreat machine so you don’t break the rubber feet off. Below are photos that will guide you on how to place the pretreat unit on the assembled stand.
Page 6
The pretreat machine has a side panel on the right side that you will need to have access to for refilling and maintenance of the unit. Make sure you don’t block this area.
Need help?
Do you have a question about the PRETREATMaker III and is the answer not in the manual?
Questions and answers