Advertisement
Digital wireless system technical parameters
Display Device
Size
Operation Frequency
Receiving Sensitivity
Resolution
View Angle (LR/UD)
Contrast Ratio
Luminance(cd/m )
2
Response Time (ms)
Load Dump
Operating Temperature
Storage Temperature
Input Voltage Range
Dimension(
L x W x T)
Transmission Power
Wireless waterproof and shockproof digital camera
Camera
Image Pick
-
up Device
Picture Elements
Horizontal Resolution
Minimum Illumination
View Angle
Waterproof Rating
Shockproof R ating
Operating Voltage Range
Dimension
The system maintenance must be maintained by professionals, please do not open and
improve the system!
The system is only for the safe operation of equipment and not responsible for accidents!
This manual is for reference only. if unknown, or any changes, we will give no notice.
The final interpretation right belongs to the manufacturer
Color TFT-LCD
7" Digital Screen
2400 ~ 2483.5MHz
≤-86dBm(1MHZ QPSK MD300RE)
800×(RGB)×480
L/R: 70/70 U/D: 50/70
500:1
450
25
DC 12+87V/400ms
-20℃～+60℃
-30℃～+80℃
DC8V～32V （ 5W Max）
(185X122X28mm)
18dBm with Power control
1/3" Color CMOS
NTSC:960(H)X480(V);PAL:960(H)X480(V)
600 TV Lines
1 Lux
45°
IP67
10G
DC12V
127(W) x 37(H) x 24.5(D) mm
Warning
Monitor Menu Operation
Nor/Mir
PAIR
PICTURE
1) Pair: Establish the connection between the monitor
and camera, make the system work in order.
Enter the menu, chose PAIR and press OK to enter
PAIRING SART
the pair. the monitor display PAIRING START 50. During
50
the 50 seconds, make the camera re-energized, the
monitor will show the camera image in 5~10s.
-
+
2) Picture setting：
5
Enter the menu, chose the picture and press OK,
-
+
1. Brightness: 0-10 (Press left/right to adjust)
5
2. Contrast: 0-10 (Press left/right to adjust)
-
+
3. Color: 0-10 (Press left/right to adjust)
5
3) Mirror/Normal image setting:
F
F
F
Set the CAM1 and CAM2 image in 4 modes.
4) Auto Scan setting:
1. Set CAM1 auto scan mode on/off;
2. Set CAM2 auto scan mode on/off;
3. Set the auto scan time.
-
+
5
5) Other function:
1. NTSC or PAL system switch;
ON
OFF
2. LED screen ambient light sensor on/off.
3. Electronic Label setting: Turn on/off the electronic
ON
OFF
label on CAM1.
Note:
When the monitor in SCAN mode, the CAM1 and CAM2 image will switch automatically
according the setting time. Press ▼/▲ to quit the switch.
Auto scan setting
Function set
Advertisement
