Table of Contents
Advertisement
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
Problem
– Possible cause
Remedy
No sound /power
– Volume not adjusted
Adjust the VOLUME
– Power cord not securely connected
Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
Insert (fresh) batteries correctly
– CD contains non-audio files
Press
,
once or more to skip to a CD audio
track, instead of the data file.
Display does not function properly / No
reaction to operation of any of the
controls
– Electrostatic discharge
Switch off and unplug the set. Reconnect after a
few seconds
--, Er or 01 indication
– No CD inserted
Insert a CD
– CD badly scratched or dirty
Replace/ clean CD, see Maintenance
– Laser lens steamed up
ait until lens has cleared
– CD-R/CD-RW is blank or not finalized
Use a finalized CD-R/CD-RW or suitable CD
Audio disc only
Note:
Make sure the CD is not encoded with
copyright protection technologies, as some
do not conform to the Compact Disc
standard.
The CD skips tracks
– CD damaged or dirty
Replace or clean CD
– Program/shuffle is active
Quit program/shuffle mode
Note: A CD badly scratch or dirty may result in
improper operation.
Specifications
Power consumption
Active....................................................................) 15W
Standby...............................................................) 0.7W
Dimensions ............290mm x 143mm x 240mm
Weight ..........................................................................1,62 kg
Advertisement
Table of Contents
